Skip to contentSkip to conversation

Fix network-bridge ifup problem

PATCH New Zhigang Wang 1 participant 1 message Jun 22, 2009

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Fix network-bridge ifup problem

hi,

when we want to setup a bridge without a ip address, function do_ifup will not activate the bridge.

Eg.

# ifconfig eth1
eth1      Link encap:Ethernet  HWaddr 00:19:B9:41:2C:B9  
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:5096 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:395457 (386.1 KiB)  TX bytes:0 (0.0 b)
          Interrupt:16 
# ./network-bridge start netdev=eth1 bridge=xenbr1

will leave xenbr1 inactive.

We should make the bridge active, then vif-bridge can work on the bridge.

thanks,

zhigang

share/tmp/network-bridge.new renamed from network-bridge +2 -2
@@ -111,9 +111,9 @@
             # use the info from get_ip_info()
             ip addr flush $1
             ip addr add ${addr_pfx} dev $1
-            ip link set dev $1 up
-            [ -n "$gateway" ] && ip route add default via ${gateway}
         fi
+        ip link set dev $1 up
+        [ -n "$gateway" ] && ip route add default via ${gateway}
     fi
 }
 

_______________________________________________
Xen-devel mailing list
[email protected]
http://lists.xensource.com/xen-devel