sh: Add support ESPT-GIGA borad
Subsystems (2)
PATCH 1/1 sh: Add support ESPT-GIGA borad
ESPT-Giga is SH7763-based reference board.
Board support is relatively sparse, presently supporting serial, gigabit ethernet, USB host, and MTD.
More information (in Japanese) available at:
http://www.cente.jp/product/cente_hard/ESPT-Giga.html
Signed-off-by Nobuhiro Iwamatsu <[email protected]>
--- Makefile | 5 + board/espt/Makefile | 50 +++++++ board/espt/config.mk | 9 ++ board/espt/espt.c | 50 +++++++ board/espt/lowlevel_init.S | 334 ++++++++++++++++++++++++++++++++++++++++++++ include/configs/espt.h | 126 +++++++++++++++++ 6 files changed, 574 insertions(+), 0 deletions(-) create mode 100644 board/espt/Makefile create mode 100644 board/espt/config.mk create mode 100644 board/espt/espt.c create mode 100644 board/espt/lowlevel_init.S create mode 100644 include/configs/espt.h
Makefile +5 -0
@@ -3511,6 +3511,11 @@ ap325rxa_config : unconfig @echo "#define CONFIG_AP325RXA 1" > $(obj)include/config.h @$(MKCONFIG) -a $(@:_config=) sh sh4 ap325rxa renesas +espt_config : unconfig + @mkdir -p $(obj)include + @echo "#define CONFIG_ESPT 1" > $(obj)include/config.h + @$(MKCONFIG) -a $(@:_config=) sh sh4 espt + #======================================================================== # SPARC #========================================================================
board/espt/Makefile new file +50 -0
50 lines not on this page · raw message
board/espt/config.mk new file +9 -0
@@ -0,0 +1,9 @@ +# +# board/espt/config.mk +# +# TEXT_BASE refers to image _after_ relocation. +# +# NOTE: Must match value used in u-boot.lds (in this directory). +# + +TEXT_BASE = 0x8FFC0000
board/espt/espt.c new file +50 -0
50 lines not on this page · raw message
board/espt/lowlevel_init.S new file +334 -0
334 lines not on this page · raw message
include/configs/espt.h new file +126 -0
126 lines not on this page · raw message
Signature · 1 line
1.6.3.1