Fix 2k pagesize NAND on i.MX27
Subsystems (3)
PATCH 1/1 Fix 2k pagesize NAND on i.MX27
This patch allows i.MX27 to support 2k pagesize NAND flash. We are using a Micron 1.8V NAND flash : MT29F4G08ABDWP-ET Without this patch, all sectors are marked as bad eraseblock.
Signed-off-by Eric Benard <[email protected]>
Acked-by Sascha Hauer <[email protected]>
--- drivers/mtd/nand/mxc_nand.c | 16 +++++++++++++++- 1 files changed, 15 insertions(+), 1 deletions(-)
drivers/mtd/nand/mxc_nand.c +15 -1
@@ -857,6 +857,17 @@ static void mxc_nand_command(struct mtd_info *mtd, unsigned command, } } +/* Define some generic bad / good block scan pattern which are used +* while scanning a device for factory marked good / bad blocks. */ +static uint8_t scan_ff_pattern[] = {0xff ,0xff }; + +static struct nand_bbt_descr smallpage_memorybased = { + .options =NAND_BBT_SCAN2NDPAGE , + .offs =5 , + .len =1 , + .pattern = scan_ff_pattern +}; +static int __init mxcnd_probe (struct platform_device *pdev) {struct nand_chip *this;
@@ -973,7 +984,10 @@ static int __init mxcnd_probe(struct platform_device *pdev) goto escan; } - host->pagesize_2k = (mtd->writesize ==2048 ) ?1 :0 ; +if (mtd->writesize ==2048 ) { + host->pagesize_2k =1 ; + this->badblock_pattern = &smallpage_memorybased; + }if (this->ecc.mode ==NAND_ECC_HW ) {switch (mtd->oobsize) {
Signature · 1 line
1.6.0.4
Quoted 6 lines · Eric Benard
This patch allows i.MX27 to support 2k pagesize NAND flash. We are using a Micron 1.8V NAND flash : MT29F4G08ABDWP-ET Without this patch, all sectors are marked as bad eraseblock.
Signed-off-by Eric Benard <[email protected]>Acked-by Sascha Hauer <[email protected]>
The previous version of your patch is sitting in l2-mtd-2.6.git and waiting for dwmw2 already.
Signature · 2 lines
Best Regards, Artem Bityutskiy (Артём Битюцкий)