b43: LP-PHY: Two small spec updates

The specs are beginning to support rev3 LP-PHYs - implement one of the changes needed for rev3 support.
Also, in the new MIPS driver, the "Japan TX filter" was renamed to "analog TX filter init" - however, calling it "init" is confusing, so name it "set analog filter", with a comment for easier future identification.

---
drivers/net/wireless/b43/phy_lp.c | 17 ++++++++++++-----

1 files changed, 12 insertions(+), 5 deletions(-)

index 6c69cdb..65f0010 100644
@@ -609,9 +609,14 @@ static void lpphy_2063_init(struct b43_wldev *dev)

	b43_radio_write(dev, B2063_PA_SP7, 0);
	b43_radio_write(dev, B2063_TX_RF_SP6, 0x20);
	b43_radio_write(dev, B2063_TX_RF_SP9, 0x40);

- b43_radio_write(dev, B2063_PA_SP3, 0xa0);
- b43_radio_write(dev, B2063_PA_SP4, 0xa0);
- b43_radio_write(dev, B2063_PA_SP2, 0x18);
+ if (dev->phy.rev == 2) {
+ b43_radio_write(dev, B2063_PA_SP3, 0xa0);
+ b43_radio_write(dev, B2063_PA_SP4, 0xa0);
+ b43_radio_write(dev, B2063_PA_SP2, 0x18);
+ } else {
+ b43_radio_write(dev, B2063_PA_SP3, 0x20);
+ b43_radio_write(dev, B2063_PA_SP2, 0x20);
+ }
}

struct lpphy_stx_table_entry {
@@ -1996,7 +2001,9 @@ static int lpphy_b2062_tune(struct b43_wldev *dev,

	return err;
}

-static void lpphy_japan_filter(struct b43_wldev *dev, int channel) +
+/* This was previously called lpphy_japan_filter */
+static void lpphy_set_analog_filter(struct b43_wldev *dev, int channel)

{
	struct b43_phy_lp *lpphy = dev->phy.lp;
	u16 tmp = (channel == 14); //SPEC FIXME check japanwidefilter!
@@ -2165,7 +2172,7 @@ static int b43_lpphy_op_switch_channel(struct b43_wldev *dev,
		err = lpphy_b2062_tune(dev, new_channel);
		if (err)
			return err;
-		lpphy_japan_filter(dev, new_channel);
+		lpphy_set_analog_filter(dev, new_channel);
		lpphy_adjust_gain_table(dev, channel2freq_lp(new_channel));
	}

1.6.2.4