Skip to contentSkip to conversation

Dump from dvr0 at constant rate even on no-signal

linux-dvb Andrea Assorgia 1 participant 1 message Sep 4, 2009 Media (V4L/DVB)

lore
Share & tools
lore
#0 lore raw

Hello to all

I'm dumping a dvb-t stream from dvr0 using tzap -r

The problem is that in case of temporary signal loss the stream outputs no data, producing recordings slightly shorter then one would expect. For example, if I dump the stream for half an hour, and during that time, some signal loss occur for a total of 10 seconds I get an mpeg of 1790 secs instead of 1800.

Is there a way to tell tzap (or some other mean of dumping from dvb-t) to stream blank frames instead of handing no data at all in case of signal loss?

I've been trying to use ffmpeg to mux the stream with a local (and thus more stable) silent audio track, but with poor results. Do you think this is the right way and deserve some more investingation?

Has anyone had the same problem and solved it?

Thanks for your replies.

Andrea Assorgia

Signature · 13 lines
Andrea Assorgia
Acagliari.it

email: [email protected]
mob: +39 328 7544769



_______________________________________________
linux-dvb users mailing list
For V4L/DVB development, please use instead [email protected]
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb