ARM: add missing HAVE_KERNEL_GZIP
PATCH 1/1 ARM: add missing HAVE_KERNEL_GZIP
Kernel fails to uncompress itself and boot without this patch.
---
No idea if this is the correct or even needed fix. I did observe a failure to boot with a post 2.6.31 kernel about two weeks ago without this patch (from u-boot), but it might well have become irrelevant by now.
arch/arm/Kconfig +1 -0
@@ -18,6 +18,7 @@ config ARM select HAVE_KRETPROBES if (HAVE_KPROBES) select HAVE_FUNCTION_TRACER if (!XIP_KERNEL) select HAVE_GENERIC_DMA_COHERENT + select HAVE_KERNEL_GZIP help The ARM series is a line of low-power-consumption RISC chip designs licensed by ARM Ltd and targeted at embedded applications and
PATCH 1/1 ARM: add missing HAVE_KERNEL_GZIP
Hi Guennadi,
Quoted 1 line · Guennadi Liakhovetski
Kernel fails to uncompress itself and boot without this patch.
I have no problem booting yesterday's linus/master without that change.
What is the exact problem you see?
Best regards
Uwe
Signature · 2 lines
Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |
PATCH 1/1 ARM: add missing HAVE_KERNEL_GZIP
Quoted 7 lines · Uwe Kleine-K?nig
Hi Guennadi,
Quoted 1 line · Guennadi Liakhovetski
Kernel fails to uncompress itself and boot without this patch.
I have no problem booting yesterday's linus/master without that change.
What is the exact problem you see?
Don't remember the error message exactly - something like "cannot uncompress" or "missing decompressor"... Observed on a i.MX31 system, although, if the problem were real, it probably would be present on all ARMs - none defines any of those decompressors. Will have to double-check then.
Thanks
Guennadi
---
Guennadi Liakhovetski, Ph.D.
Freelance Open-Source Software Developer
http://www.open-technology.de/
PATCH 1/1 ARM: add missing HAVE_KERNEL_GZIP
Quoted 8 lines · Somebody in the thread at some point
Quoted 6 lines · Uwe Kleine-K?nig
Hi Guennadi,
Quoted 1 line · Guennadi Liakhovetski
Kernel fails to uncompress itself and boot without this patch.
I have no problem booting yesterday's linus/master without that change.
Quoted 7 lines
Quoted 1 line
What is the exact problem you see?
Don't remember the error message exactly - something like "cannot uncompress" or "missing decompressor"... Observed on a i.MX31 system, although, if the problem were real, it probably would be present on all ARMs - none defines any of those decompressors. Will have to double-check then.
Just a comment on this, I run on an iMX device with an uncompressed kernel for a nice decrease in early boot time. The kernel comes in at 3MB uncompressed and the Qi bootloader I used pulls that in around half a second from uSD.
I use gzip for something else as it happens, but in the uncompressed case, boot is not dependent on gzip in the kernel.
-Andy