gpio: Added timbgpio
PATCH 1/1 gpio: Added timbgpio
Supplied is a GPIO driver for the Timberdale FPGA found on the Intel Atom board Russellville.
The GPIO driver also have a IRQ-chip to support interrupts on the pins.
Signed-off-by Richard Röjfors <[email protected]>
---
drivers/gpio/Kconfig +6 -0
@@ -196,6 +196,12 @@ config GPIO_LANGWELL help Say Y here to support Intel Moorestown platform GPIO. +config GPIO_TIMBERDALE + bool "Support for timberdale GPIO IP" + depends on MFD_TIMBERDALE && GPIOLIB && HAS_IOMEM + ---help--- + Add support for the GPIO IP in the timberdale FPGA. + comment "SPI GPIO expanders:" config GPIO_MAX7301
drivers/gpio/Makefile +1 -0
@@ -13,6 +13,7 @@ obj-$(CONFIG_GPIO_MCP23S08) += mcp23s08.o obj-$(CONFIG_GPIO_PCA953X) += pca953x.o obj-$(CONFIG_GPIO_PCF857X) += pcf857x.o obj-$(CONFIG_GPIO_PL061) += pl061.o +obj-$(CONFIG_GPIO_TIMBERDALE) += timbgpio.o obj-$(CONFIG_GPIO_TWL4030) += twl4030-gpio.o obj-$(CONFIG_GPIO_UCB1400) += ucb1400_gpio.o obj-$(CONFIG_GPIO_XILINX) += xilinx_gpio.o
drivers/gpio/timbgpio.c new file +342 -0
342 lines not on this page · raw message
include/linux/timb_gpio.h new file +37 -0
@@ -0,0 +1,37 @@ +/* +* timb_gpio.h timberdale FPGA GPIO driver, platform data definition +* Copyright (c) 2009 Intel Corporation +* +* This program is free software; you can redistribute it and/or modify +* it under the terms of the GNU General Public License version 2 as +* published by the Free Software Foundation. +* +* This program is distributed in the hope that it will be useful, +* but WITHOUT ANY WARRANTY; without even the implied warranty of +* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the +* GNU General Public License for more details. +* +* You should have received a copy of the GNU General Public License +* along with this program; if not, write to the Free Software +* Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. +*/ + +#ifndef _LINUX_TIMB_GPIO_H +#define _LINUX_TIMB_GPIO_H + +/** +* struct timbgpio_platform_data - Platform data of the Timberdale GPIO driver +* @gpio_base The number of the first GPIO pin, set to -1 for +* dynamic number allocation. +* @nr_pins Number of pins that is supported by the hardware (1-32) +* @irq_base If IRQ is supported by the hardware, this is the base +* number of IRQ:s. One IRQ per pin will be used. Set to +* -1 if IRQ:s is not supported. +*/ +struct timbgpio_platform_data { +int gpio_base; +int nr_pins; +int irq_base; +}; + +#endif