c67x00 with mpc85xx
We are using the Cypress USB Host (CY7C67300) with a Freescale MPC8544 and can only get it to work if we add a delay after writing to the hardware registers through the HPI.
We tried playing with the SCY settings in the GPCM but nothing helps. It is only when we add usecs of delay after our write() functions that the hardware works.
The datasheets make no mention of any write-then-read requirements and the FAEs are stumped right now.
I was just hoping somebody had some experiencing interfacing this chip to the PowerPC and that they could offer some suggestions or ideas.
TIA,
Jeff
Signature · 3 lines
Jeff Angielski The PTR Group www.theptrgroup.com
Quoted 9 lines · Jeff Angielski
We are using the Cypress USB Host (CY7C67300) with a Freescale MPC8544 and can only get it to work if we add a delay after writing to the hardware registers through the HPI.
We tried playing with the SCY settings in the GPCM but nothing helps. It is only when we add usecs of delay after our
write()functions that the hardware works.
Quoted 5 lines
The datasheets make no mention of any write-then-read requirements and the FAEs are stumped right now.
I was just hoping somebody had some experiencing interfacing this chip to the PowerPC and that they could offer some suggestions or ideas.
I've worked with the part attached to the ppc440 inside a Xilinx FPGA.
Though I ran into many problems, I haven't seen the problem that you
describe. Sorry.
g.
Signature · 2 lines
Grant Likely, B.Sc., P.Eng. Secret Lab Technologies Ltd.