Skip to contentSkip to conversation

AT91SAM9260 Ethernet Device

U-Boot J.Hwan.Kim 2 participants 2 messages Nov 30, 2009 – Dec 1, 2009

lore
Share & tools
lore

J.Hwan.Kim

author
#0 lore raw

Hi, everyone

I'm trying to connect ethernet with AT91SAM9260.
My board uses DM9161A as a ethernet transceiver.

The u-boot ethernet initialization routine runs auto-negotiation, it works fine. Ethernet controller of AT91SAM9260 (MACB0) receives Auto negotiation completion bit
from DM9161A status register.

But status registor of DM9161A returns "Invalid link status", so u-boot prints "eth0 link down".

When does the "invalid link status" situation happen? How can I fix this problem?
I connected the ethernet with PC by cross ethernet cable.

Thanks in advance.

Best Regards,
J.Hwan Kim

#1 lore raw

Dear J.Hwan.Kim,

Quoted 10 lines

Hi, everyone

I'm trying to connect ethernet with AT91SAM9260.
My board uses DM9161A as a ethernet transceiver.

The u-boot ethernet initialization routine runs auto-negotiation, it works fine. Ethernet controller of AT91SAM9260 (MACB0) receives Auto negotiation completion bit
from DM9161A status register.

Please check phy interface mode: RMII or MII

Quoted 8 lines

But status registor of DM9161A returns "Invalid link status", so u-boot prints "eth0 link down".

When does the "invalid link status" situation happen? How can I fix this problem?
I connected the ethernet with PC by cross ethernet cable.

Which version of U-Boot do you use?
Have You test the connection with an ethernet siwtch?

Best Regards,
J. Scharsig