Skip to contentSkip to conversation

Asus NX1001 (ipg driver) jumbo frames

DISCUSSION Hinko Kocevar 1 participant 1 message Dec 21, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

Hi,

I'm using Gentoo based Linux version 2.6.31 from Gentoo portage. I've recently added Asus NX1001 PCI Gigabit network card to my system. The card is recognized and driver ipg for Linux is used. Since I want to used jumbo frames, I set the MTU (using ifconfig) to 9000 bytes with success.

When the remote site is sending a jumbo frame, wireshark sitting on my Asus 1001 Gbe is not showing any packets. But, I can see that 'Rx bytes' value in ifconfig eth1 has incremented appropriately.

Example:
1. receiving side, no packet yet sent from the transmitting side:
support-pc support # ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:22:15:10:b8:48
inet addr:192.168.1.1 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::222:15ff:fe10:b848/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:7200 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:588 (588.0 B) Interrupt:21

2. one jumbo frame is received (wireshark shows nothing)
3. receiving side, one packet seen only in Rx bytes lines:
support-pc support # ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:22:15:10:b8:48
inet addr:192.168.1.1 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::222:15ff:fe10:b848/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:7200 Metric:1 RX packets:1 errors:0 dropped:0 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000
RX bytes:6140 (5.9 KiB) TX bytes:588 (588.0 B) Interrupt:21

I see that there has been some MTU code changes in the past (2.6.26).

Can anyone confirm that jumbo frames are working on ipg driver in recent kernels (2.6.31)? Are there any known issues with this driver?

I can also confirm, that remote side is working as expected (in regard to jumbo frames) because I've tested another Gigabit NIC (using r8169 driver) - whose MTU can be set to only 7200 bytes.

Best regards,
Hinko

Signature · 14 lines
Hinko Kocevar
Technical support software engineer
Instrumentation Technologies
Velika pot 22, SI-5250 Solkan - Slovenia
T:+386 5 3352600, F:+386 5 3352601
mailto: [email protected]

http://www.i-tech.si - When your users demand stability

The information transmitted is intended solely for the addressee and may
contain confidential and/or privileged information. Any review, retention,
disclosure or other use by persons other than the intended recipient is
prohibited. If you received this in error, please notify the sender and
delete all copies.