The use_count problem of regulator
Hi, all.
I have one simple question.
In the regulator framework, if the regulator is enabled for example by boot_on constraint, when regulator_get is called at the driver probe function, the use_count of struct regulator_dev is zero. But if regulator_has_full_constraints() is used, even though above the regulator is using, it is disabled by regulator_init_complete() because the use_count is zero.
Of course, we can use regulator_get_exclusive instead of regulator_get, but if the regulator can be shared, i think this will be a problem.
Thanks.
Quoted 6 lines · Joonyoung Shim
In the regulator framework, if the regulator is enabled for example by
boot_onconstraint, whenregulator_getis called at the driver probe function, theuse_countof structregulator_devis zero. But ifregulator_has_full_constraints()is used, even though above the regulator is using, it is disabled byregulator_init_complete()because theuse_countis zero.
This is expected behaviour if the regulator is not marked as always_on. The idea is that the regulators will have been claimed and enabled by a regulator consumer during the init process, and if it hasn't then it's not in active use at the current time and may therefore be powered off.
Quoted 2 lines
Of course, we can use
regulator_get_exclusiveinstead ofregulator_get, but if the regulator can be shared, i think this will be a problem.
If the consumer is using the regulator then it should enable the regulator without reference to the existing state of the regulator. This is required to support sharing of supplies - if another consumer enabled the regulator then it may later decide to turn it off when it's done with it, which would have the same effect as you're seeing from the full constraints code.
A consumer using regulator_get() should in general never need to check if the regulator is enabled except possibly during startup in order to gracefully handle the handover of the initial hardware state. Normally they should call enable() when they start using the device and disable() when they stop.