Mantis not in modules.pcimap

Hello,

The mantis module is build and working fine with the Skystar2 HD, but it I cannot autodetect it, because modules.pcimap is not filled with the vendor id of the card using this module. What's to do  to get these ID's ?
In my case its a:

01:08.0 0480: 1822:4e35 (rev 01)
       Subsystem: 1ae4:0003
       Flags: bus master, medium devsel, latency 32, IRQ 16 Memory at fddff000 (32-bit, prefetchable) [size=4K]

Hello,

The mantis module is build and working fine with the Skystar2 HD, but it I cannot autodetect it, because modules.pcimap is not filled with the vendor id of the card using this module. What's to do to get these ID's ?
In my case its a:

01:08.0 0480: 1822:4e35 (rev 01)

	Subsystem: 1ae4:0003
	Flags: bus master, medium devsel, latency 32, IRQ 16
	Memory at fddff000 (32-bit, prefetchable) [size=4K]

Quoted 11 lines · Helmut Auer

Hello,

The mantis module is build and working fine with the Skystar2 HD, but it I cannot autodetect it, because modules.pcimap is not filled with the vendor id of the card using this module. What's to do  to get these ID's ?
In my case its a:

01:08.0 0480: 1822:4e35 (rev 01)
      Subsystem: 1ae4:0003
      Flags: bus master, medium devsel, latency 32, IRQ 16 Memory at fddff000 (32-bit, prefetchable) [size=4K]

Running

 # depmod -a

as root should have added it.  The mantis driver is likely missing a MODULE_DEVICE_TABLE() macro invocation.

Cc -ing Manu.