Problem with AR5001 on eeepc900A after disable with RFKILL switch
This problem is reported at
https://bugzilla.novell.com/show_bug.cgi?id=595586.
Although not mentioned in the bug report, the kernel is 2.6.33.
The initial part of the report is as follows:
======================================================================
After disabling WLAN on Asus eeepc 900A using rfkill button (Fn+F2) it does not get back into a working state without a reboot.
Reproducible: Always
Steps to Reproduce:
1. boot up eeepc900A with WLAN enabled
2. press Fn+F2 (rfkill button) to disable WLAN
3. press Fn+F2 again to enable WLAN
Actual Results:
-----
1. lspci before rfkill
01:00.0 Ethernet controller: Atheros Communications AR8121/AR8113/AR8114 Gigabit or Fast Ethernet (rev b0)
02:00.0 Ethernet controller: Atheros Communications Inc. AR5001 Wireless Network Adapter (rev 01)
-----
2. lspci after rfkill
01:00.0 Ethernet controller: Attansic Technology Corp. Atheros AR8121/AR8113/AR8114 PCI-E Ethernet Controller (rev b0) 02:00.0 Ethernet controller: Atheros Communications Inc. AR5001 Wireless Network Adapter (rev ff)
======================================================================
The curious thing is that the lspci output is different for both the wired and wireless cards.
Any ideas on why setting rfkill should change data in this way?
Thanks,
Larry
Quoted 20 lines · Larry Finger
This problem is reported at
https://bugzilla.novell.com/show_bug.cgi?id=595586.Although not mentioned in the bug report, the kernel is 2.6.33.
The initial part of the report is as follows:
======================================================================
After disabling WLAN on Asus eeepc 900A using rfkill button (Fn+F2) it does not get back into a working state without a reboot.
Reproducible: Always
Steps to Reproduce:
1. boot up eeepc900A with WLAN enabled
2. press Fn+F2 (rfkill button) to disable WLAN
3. press Fn+F2 again to enable WLAN
Actual Results:
Quoted 12 lines
-----
1. lspci before rfkill
01:00.0 Ethernet controller: Atheros Communications AR8121/AR8113/AR8114 Gigabit or Fast Ethernet (rev b0)
02:00.0 Ethernet controller: Atheros Communications Inc. AR5001 Wireless Network Adapter (rev 01)
-----
2. lspci after rfkill
01:00.0 Ethernet controller: Attansic Technology Corp. Atheros AR8121/AR8113/AR8114 PCI-E Ethernet Controller (rev b0) 02:00.0 Ethernet controller: Atheros Communications Inc. AR5001 Wireless Network Adapter (rev ff)
Weird..
So it says 'Attansic' on the ethernet only after rfkill is re-enabled? The 0xff revision on wifi makes slightly more sense, if it's some issue like broken PCI config space reads.
IIRC rfkill switch on those platforms cuts the bus power; I don't think ath5k participates specifically. I assume the eepc-laptop driver is loaded?
Signature · 1 line
Bob Copeland %% www.bobcopeland.com