imx27: I2C clock frequency

Hi!
When investigating the i2c clock frequency on our custom imx27-board (running 2.6.32) we discovered that it was not correct, instead of 100khz we got 40khz. When looking at the code we noticed a possible problem with get_rate_ipg. With the following patch we get an i2c clock at 100khz (as expected).

Is this the right way to solve the problem? I am unsure if I can use the AHB divider directly for the ipgclock-rate.

@@ -401,7 +401,7 @@ static unsigned long get_rate_ipg(struct
 	unsigned long rate, ipg_pdf;
 
 	if (mx27_revision() >= CHIP_REV_2_0)
-		return clk_get_rate(clk->parent);
+		ipg_pdf = (__raw_readl(CCM_CSCR) >> 8) & 3;
 	else
 		ipg_pdf = (__raw_readl(CCM_CSCR) >> 8) & 1;
 

Best regards

Mattias Walstr?m