EG20T: Update PCH_UART driver to 2.6.36
PATCH v4 1/1 EG20T: Update PCH_UART driver to 2.6.36
Hi Dan Carpenter,
I have modified for your indications.
Please check below.
Signature · 19 lines
Thanks, Tomoya MORINAGA(OKI SEMICONDUCTOR CO., LTD.) --- UART driver of Intel EG20T(Topcliff) PCH Intel EG20T PCH is the platform controller hub that is going to be used in Intel's general embedded platform. All IO peripherals in Intel EG20T PCH are actually devices sitting on AMBA bus. Intel EG20T PCH has UART I/F. Using this I/F, it is able to access system devices connected to UART. Signed-off-by: Tomoya MORINAGA <[email protected]> --- drivers/serial/Kconfig | 8 + drivers/serial/Makefile | 1 + drivers/serial/pch_uart.c | 1464 +++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 1473 insertions(+), 0 deletions(-) create mode 100644 drivers/serial/pch_uart.c
drivers/serial/Kconfig +8 -0
@@ -1611,4 +1611,12 @@ config SERIAL_ALTERA_UART_CONSOLE help Enable a Altera UART port to be the system console. +config SERIAL_PCH_UART + tristate "Intel EG20T PCH UART" + select SERIAL_CORE + depends on PCI + help + This driver is for PCH(Platform controller Hub) UART of Intel EG20T + which is an IOH(Input/Output Hub) for x86 embedded processor. + Enabling PCH_DMA, this PCH UART works as DMA mode. endmenu
drivers/serial/Makefile +1 -0
@@ -88,3 +88,4 @@ obj-$(CONFIG_SERIAL_ALTERA_JTAGUART) += altera_jtaguart.o obj-$(CONFIG_SERIAL_ALTERA_UART) += altera_uart.o obj-$(CONFIG_SERIAL_MRST_MAX3110) += mrst_max3110.o obj-$(CONFIG_SERIAL_MFD_HSU) += mfd.o +obj-$(CONFIG_SERIAL_PCH_UART) += pch_uart.o
drivers/serial/pch_uart.c new file +1464 -0
1,464 lines not on this page · raw message
Signature · 1 line
1.6.0.6