Skip to contentSkip to conversation

MX51EVK: UART does not print out the early information

PATCH New Jason Liu 2 participants 2 messages Dec 23, 2010 – Dec 27, 2010

lore
Share & tools
lore

Jason Liu

author
#0 lore raw

PATCH 1/1 MX51EVK: UART does not print out the early information

The early bootup information is not print out due to the UART pin iomux not set up correctly before board_init

Add the board_early_init_f function and enable the CONFIG_BOARD_EARLY_INIT_F. Move the UART pin setting from board_init to board_early_init_f function.

This patch also move the FEC pin iomux setup to the board_early_init_f.

---
 board/freescale/mx51evk/mx51evk.c |   11 ++++++++---
 include/configs/mx51evk.h         |    2 ++
 2 files changed, 10 insertions(+), 3 deletions(-)
board/freescale/mx51evk/mx51evk.c +8 -3
index 2160d5a..7c50c54 100644
@@ -399,6 +399,14 @@ int board_mmc_init(bd_t *bis)
 }
 #endif
 
+int board_early_init_f(void)
+{
+	setup_iomux_uart();
+	setup_iomux_fec();
+
+	return 0;
+}
+
 int board_init(void)
 {
 	system_rev = get_cpu_rev();
@@ -407,9 +415,6 @@ int board_init(void)
 	/* address of boot parameters */
 	gd->bd->bi_boot_params = PHYS_SDRAM_1 + 0x100;
 
-	setup_iomux_uart();
-	setup_iomux_fec();
-
 	return 0;
 }
 
include/configs/mx51evk.h +2 -0
index 3d6d390..591d6e1 100755
@@ -202,6 +202,8 @@
 #define CONFIG_SYS_INIT_RAM_ADDR	(IRAM_BASE_ADDR)
 #define CONFIG_SYS_INIT_RAM_SIZE	(IRAM_SIZE)
 
+#define CONFIG_BOARD_EARLY_INIT_F
+
 #define CONFIG_SYS_INIT_SP_OFFSET \
 	(CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 #define CONFIG_SYS_INIT_SP_ADDR \
Signature · 1 line
1.7.0.4
#1 lore raw

PATCH 1/1 MX51EVK: UART does not print out the early information

Quoted 7 lines · Jason Liu

The early bootup information is not print out due to the UART pin iomux not set up correctly before board_init

Add the board_early_init_f function and enable the CONFIG_BOARD_EARLY_INIT_F. Move the UART pin setting from board_init to board_early_init_f function.

Quoted 5 lines

This patch also move the FEC pin iomux setup to the board_early_init_f.

---

Applied to u-boot-imx, thanks.

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================