Skip to contentSkip to conversation

cassini: Use local-mac-address prom property for

PATCH Applied Richard Mortimer 2 participants 5 messages Jan 6, 2011 – Jan 15, 2011 Network drivers

lore
Share & tools
lore
#0 lore raw

PATCH v3 1/1 cassini: Use local-mac-address prom property for

From 603b3377a6857448006c886f10c607d07c102b64 Mon Sep 17 00:00:00 2001
From: Richard Mortimer <[email protected]>
Date: Thu, 6 Jan 2011 00:08:54 +0000
Subject: [PATCH] cassini: Use local-mac-address prom property for Cassini MAC address

Fallback on the local-mac-address prom property if the Cassini device does not have an address programmed in the VPD ROM. This uses the same technique as implemented by the sungem driver.

The problem was reported by Frans van Berckel using Debian kernel 2.6.34-7 on Sun Fire V440. udev was assigning a new eth<n> device name on each reboot because the cassini driver was using a random MAC address.

Fix tested on 2.6.34-7 and 2.6.37 Sun Fire V440. Compile tested against 2.6.36 davem/sparc-2.6.git

---
 drivers/net/cassini.c |   16 ++++++++++++++++
 drivers/net/cassini.h |    3 +++
 2 files changed, 19 insertions(+), 0 deletions(-)
drivers/net/cassini.c +16 -0
index d6b6d6a..e259c18 100644
@@ -3203,6 +3203,10 @@ static int cas_get_vpd_info(struct cas *cp, unsigned char *dev_addr,
 	int phy_type = CAS_PHY_MII_MDIO0; /* default phy type */
 	int mac_off  = 0;
 
+#if defined(CONFIG_OF)
+	const unsigned char *addr;
+#endif
+
 	/* give us access to the PROM */
 	writel(BIM_LOCAL_DEV_PROM | BIM_LOCAL_DEV_PAD,
 	       cp->regs + REG_BIM_LOCAL_DEV_EN);
@@ -3350,6 +3354,14 @@ use_random_mac_addr:
 	if (found & VPD_FOUND_MAC)
 		goto done;
 
+#if defined(CONFIG_OF)
+	addr = of_get_property(cp->of_node, "local-mac-address", NULL);
+	if (addr != NULL) {
+		memcpy(dev_addr, addr, 6);
+		goto done;
+	}
+#endif
+
 	/* Sun MAC prefix then 3 random bytes. */
 	pr_info("MAC address not found in ROM VPD\n");
 	dev_addr[0] = 0x08;
@@ -5019,6 +5031,10 @@ static int __devinit cas_init_one(struct pci_dev *pdev,
 	cp->msg_enable = (cassini_debug < 0) ? CAS_DEF_MSG_ENABLE :
 	  cassini_debug;
 
+#if defined(CONFIG_OF)
+	cp->of_node = pci_device_to_OF_node(pdev);
+#endif
+
 	cp->link_transition = LINK_TRANSITION_UNKNOWN;
 	cp->link_transition_jiffies_valid = 0;
 
drivers/net/cassini.h +3 -0
index dbc4787..faf4746 100644
@@ -2868,6 +2868,9 @@ struct cas {
 	dma_addr_t block_dvma, tx_tiny_dvma[N_TX_RINGS];
 	struct pci_dev *pdev;
 	struct net_device *dev;
+#if defined(CONFIG_OF)
+	struct device_node	*of_node;
+#endif
 
 	/* Firmware Info */
 	u16			fw_load_addr;
Signature · 1 line
1.4.4.4
maintainer Applied
#1 lore raw

From: Richard Mortimer <[email protected]>
Date: Thu, 06 Jan 2011 14:34:15 +0000

Quoted 13 lines
Quoted 1 line

From 603b3377a6857448006c886f10c607d07c102b64 Mon Sep 17 00:00:00 2001

From: Richard Mortimer <[email protected]>
Date: Thu, 6 Jan 2011 00:08:54 +0000
Subject: [PATCH] cassini: Use local-mac-address prom property for Cassini MAC address

Fallback on the local-mac-address prom property if the Cassini device does not have an address programmed in the VPD ROM. This uses the same technique as implemented by the sungem driver.

The problem was reported by Frans van Berckel using Debian kernel 2.6.34-7 on Sun Fire V440. udev was assigning a new eth<n> device name on each reboot because the cassini driver was using a random MAC address.

Quoted 8 lines

Fix tested on 2.6.34-7 and 2.6.37 Sun Fire V440. Compile tested against 2.6.36 davem/sparc-2.6.git

Applied, thanks a lot.

#2 lore raw

Re: [PATCH v3] cassini: Use local-mac-address prom property for Cassini

In reply to Richard Mortimer

All,

FYI Sinan Akman has reported that cassini does not compile for x86 any longer. Message included below.

Does anyone have suggestions as to the best way to resolve this?

Also are there any other lists that this should be forwarded to?

Regards

Richard

-------- Original Message --------
Subject: Re: [PATCH] cassini: Use local-mac-address prom property for Cassini MAC address
Date: Thu, 13 Jan 2011 20:28:54 -0500
From: Sinan Akman <[email protected]>
To: [email protected]

Richard, cassini doesn't compile now for x86 after :

http://www.spinics.net/lists/sparclinux/msg07607.html

pci_device_to_OF_node is not defined for all archs so perhaps you are better of leaving CONFIG_SPARC instead of having CONFIG_OF.

Feel free to forward this to list (did this ever
appear in lmkl or only sparclinux ?).

If you have another patch on that and cc me I can
compile test for you on x86.

-- sinan

Quoted 30 lines · David Miller

From: Richard Mortimer<[email protected]>
Date: Thu, 06 Jan 2011 14:34:15 +0000

Quoted 13 lines
Quoted 1 line

From 603b3377a6857448006c886f10c607d07c102b64 Mon Sep 17 00:00:00 2001

From: Richard Mortimer<[email protected]>
Date: Thu, 6 Jan 2011 00:08:54 +0000
Subject: [PATCH] cassini: Use local-mac-address prom property for Cassini MAC address

Fallback on the local-mac-address prom property if the Cassini device does not have an address programmed in the VPD ROM. This uses the same technique as implemented by the sungem driver.

The problem was reported by Frans van Berckel using Debian kernel 2.6.34-7 on Sun Fire V440. udev was assigning a new eth<n> device name on each reboot because the cassini driver was using a random MAC address.

Quoted 8 lines

Fix tested on 2.6.34-7 and 2.6.37 Sun Fire V440. Compile tested against 2.6.36 davem/sparc-2.6.git

Applied, thanks a lot.
--
To unsubscribe from this list: send the line "unsubscribe sparclinux" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

maintainer
#3 lore raw

Re: [PATCH v3] cassini: Use local-mac-address prom property for Cassini MAC address

From: Richard Mortimer <[email protected]>
Date: Fri, 14 Jan 2011 11:39:28 +0000

Quoted 4 lines

FYI Sinan Akman has reported that cassini does not compile for x86 any longer. Message included below.

Does anyone have suggestions as to the best way to resolve this?

I'll fix it like this:

--------------------
cassini: Fix build bustage on x86.

Unfortunately, not all CONFIG_OF platforms provide pci_device_to_OF_node().

Change the test to CONFIG_SPARC for now to deal with the build regressions.

---
 drivers/net/cassini.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)
drivers/net/cassini.c +3 -3
index 7206ab2..3437613 100644
@@ -3203,7 +3203,7 @@ static int cas_get_vpd_info(struct cas *cp, unsigned char *dev_addr,
 	int phy_type = CAS_PHY_MII_MDIO0; /* default phy type */
 	int mac_off  = 0;
 
-#if defined(CONFIG_OF)
+#if defined(CONFIG_SPARC)
 	const unsigned char *addr;
 #endif
 
@@ -3354,7 +3354,7 @@ use_random_mac_addr:
 	if (found & VPD_FOUND_MAC)
 		goto done;
 
-#if defined(CONFIG_OF)
+#if defined(CONFIG_SPARC)
 	addr = of_get_property(cp->of_node, "local-mac-address", NULL);
 	if (addr != NULL) {
 		memcpy(dev_addr, addr, 6);
@@ -5031,7 +5031,7 @@ static int __devinit cas_init_one(struct pci_dev *pdev,
 	cp->msg_enable = (cassini_debug < 0) ? CAS_DEF_MSG_ENABLE :
 	  cassini_debug;
 
-#if defined(CONFIG_OF)
+#if defined(CONFIG_SPARC)
 	cp->of_node = pci_device_to_OF_node(pdev);
 #endif
 
Signature · 1 line
1.7.3.4
#4 lore raw

Re: [PATCH v3] cassini: Use local-mac-address prom property for Cassini MAC address

Quoted 10 lines · David Miller

From: Richard Mortimer <[email protected]>
Date: Fri, 14 Jan 2011 11:39:28 +0000

Quoted 4 lines

FYI Sinan Akman has reported that cassini does not compile for x86 any longer. Message included below.

Does anyone have suggestions as to the best way to resolve this?

I'll fix it like this:

Thank you.

Regards

Richard