Skip to contentSkip to conversation

Linksys WUSB600N v2 with rt2x00 driver doesn't work

DISCUSSION Ozan Çağlayan 1 participant 1 message Mar 28, 2011

lore
Share & tools
lore

Ozan Çağlayan

author Acked-by Ivo van Doorn
#0 lore raw

Hi,

The mentioned dongle's vendor&product id is added to the rt2800usb driver with the following commit:

commit 5e31258945f60dff65952575625cac214a75893e

Author: Gertjan van Wingerde <[email protected]>
Date:   Wed Dec 23 00:03:21 2009 +0100

rt2x00: Add USB ID for Linksys WUSB 600N rev 2.

This is a rt2870 based device.

On 2.6.37.5 with compat-wireless 2.6.38.3, the driver gets loaded, the interface wlan0 is created but no scan results is returned. These are what logged in dmesg after plugging the device:

[336770.008134] usb 2-3: new high speed USB device using ehci_hcd and address 6
[336770.154067] usb 2-3: New USB device found, idVendor=1737, idProduct=0079
[336770.154071] usb 2-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[336770.154075] usb 2-3: Product: Linksys WUSB600N Wireless-N USB Network Adapter with Dual-Band ver. 2
[336770.154078] usb 2-3: Manufacturer: Linksys
[336770.156447] usbip 2-3:1.0: this device 2-3 is not in match_busid table. skip!
[336770.171767] ieee80211 phy2: Selected rate control algorithm 'minstrel_ht'
[336770.172614] Registered led device: rt2800usb-phy2::radio
[336770.172653] Registered led device: rt2800usb-phy2::assoc
[336770.172734] Registered led device: rt2800usb-phy2::quality
[336770.900090] ADDRCONF(NETDEV_UP): wlan0: link is not ready

ozanDesktopI7x86_64 rt2x00 # ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 68:7F:74:F5:E8:1A
UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

ozanDesktopI7x86_64 rt2x00 # rfkill list
2: phy2: Wireless LAN
Soft blocked: no
Hard blocked: no