powerpc/eeh: Propagate needs_freset flag to device at PE

From: Richard A Lary <[email protected]>

For multifunction adapters with a PCI bridge or switch as the device at the Partitionable Endpoint(PE), if one or more devices below PE sets dev->needs_freset, that value will be set for the PE device.

In other words, if any device below PE requires a fundamental reset the PE will request a fundamental reset.

Signed-off-by Richard A Lary <[email protected]>

---

arch/powerpc/platforms/pseries/eeh.c | 48 42 + 6 - 0 !

  1 file changed, 42 insertions(+), 6 deletions(-)

Index: b/arch/powerpc/platforms/pseries/eeh.c
===================================================================

arch/powerpc/platforms/pseries/eeh.c +42 -6

@@ -448,6 +448,39 @@ void eeh_clear_slot (struct device_node
  	raw_spin_unlock_irqrestore(&confirm_error_lock, flags);
  }
 
+void __eeh_set_pe_freset(struct device_node *parent, unsigned int *freset)
+{
+	struct device_node *dn;
+
+	for_each_child_of_node(parent, dn) {
+		if (PCI_DN(dn)) {
+
+			struct pci_dev *dev = PCI_DN(dn)->pcidev;
+
+			if (dev && dev->driver)
+				*freset |= dev->needs_freset;
+
+			__eeh_set_pe_freset(dn, freset);
+		}
+	}
+}
+
+void eeh_set_pe_freset(struct device_node *dn, unsigned int *freset)
+{
+	struct pci_dev *dev;
+	dn = find_device_pe(dn);
+
+	/* Back up one, since config addrs might be shared */
+	if (!pcibios_find_pci_bus(dn) && PCI_DN(dn->parent))
+		dn = dn->parent;
+
+	dev = PCI_DN(dn)->pcidev;
+	if (dev)
+		*freset |= dev->needs_freset;
+
+	__eeh_set_pe_freset(dn, freset);
+}
+
  /**
   * eeh_dn_check_failure - check if all 1's data is due to EEH slot freeze
   * @dn device node

@@ -736,18 +769,21 @@ int pcibios_set_pcie_reset_state(struct
  /**
   * rtas_set_slot_reset -- assert the pci #RST line for 1/4 second
   * @pdn: pci device node to be reset.
- *
- *  Return 0 if success, else a non-zero value.
   */
 
  static void __rtas_set_slot_reset(struct pci_dn *pdn)
  {
-	struct pci_dev *dev = pdn->pcidev;
+	unsigned int freset = 0;
 
-	/* Determine type of EEH reset required by device,
-	 * default hot reset or fundamental reset
+	/* Determine type of EEH reset required for
+	 * Partitionable Endpoint, a hot-reset (1)
+	 * or a fundamental reset (3).
+	 * A fundamental reset required by any device under
+	 * Partitionable Endpoint trumps hot-reset.
  	 */
-	if (dev && dev->needs_freset)
+	eeh_set_pe_freset(pdn->node, &freset);
+
+	if (freset)
  		rtas_pci_slot_reset(pdn, 3);
  	else
  		rtas_pci_slot_reset(pdn, 1);