HDA Intel/ALC269 microphone problem
Read a few bug reports (going back to 2009!) around where users couldn't use their microphone with HDA Intel/ALC269. I had one set up JACK for 2 playback channels and 1 capture channel, make an .asoundrc to route everything to pulse which is started with a configuration only using module-jack-sink and module-jack-source, start it up and the microphone and the whole setup worked. But that's quite a hassle for a workaround!
I had suspicions that it was the stereo mic causing problem and forcing mono would work and it seems to be the case. I attached a patch, hoping that the fix might be as simple as forcing mono at the ALSA level, but I don't think it'll be that simple... Can someone more experienced see if more is needed, and if not then commit it?
(orig file is from 3.0-rc1 source)
Signature · 1 line
Mathieu Bouffard<mbouffard fedoraproject org>
Changelog: this is probably not the only fix needed here, see the FIXME comment. I don't have the hardware to test this.
pci/hda/fixed_patch_realtek.c renamed from pci/hda/patch_realtek.c +8 -2
@@ -14659,8 +14659,14 @@static const struct hda_pcm_stream alc269_44k_pcm_analog_capture = { .substreams =1 , - .channels_min =2 , - .channels_max =2 , + .channels_min =1 , + .channels_max =1 , +/* FIXME I read multiple bug reports where ALC269 users couldn't use their microphone. I had +* one set up JACK with two channels for output, and only one for input then route +* pulseaudio's sink/source to JACK as a test. It worked, it would seem as if this +* ALC269 does not support stereo capture? The above is probably not the only fix needed +* here, leaving it up to somebody more experienced. +*/ .rates =SNDRV_PCM_RATE_44100 ,/* fixed rate */ /* NID is set in alc_build_pcms */ };