at91sam9260ek: pull up on gpio
PATCH 1/1 at91sam9260ek: pull up on gpio
This fixes floating pin PB14 (DRXD) if it is unconnected, witch cause sometimes to stop autoboot by receiving char (noise). It turns internal pull up on this pin.
It turns pull up on all other pins where should be pull up and is set in driver too.
include/configs/at91sam9260ek.h renamed from include/configs/at91sam9260ek.h.orig +1 -0
@@ -55,6 +55,7 @@* Hardware drivers */ #define CONFIG_AT91_GPIO 1 +#define CONFIG_AT91_GPIO_PULLUP 1#define CONFIG_ATMEL_USART 1#undef CONFIG_USART0#undef CONFIG_USART1
PATCH 1/1 at91sam9260ek: pull up on gpio
Dear Prchal Ji??,
Quoted 9 lines
This fixes floating pin PB14 (DRXD) if it is unconnected, witch cause sometimes to stop autoboot by receiving char (noise). It turns internal pull up on this pin.
It turns pull up on all other pins where should be pull up and is set in driver too.Signed-off-by Jiri Prchal <[email protected]>
include/configs/at91sam9260ek.h line 61
Quoted 7 lines
include/configs/at91sam9260ek.h renamed from include/configs/at91sam9260ek.h.orig +1
-0@@ -55,6 +55,7 @@* Hardware drivers */ #define CONFIG_AT91_GPIO 1 +#define CONFIG_AT91_GPIO_PULLUP 1#define CONFIG_ATMEL_USART 1#undef CONFIG_USART0#undef CONFIG_USART1
This is based on old code.
Anyway, the Pull-Ups are enabled in the current (not yet in mainline) at91sam9260ek port.
Best Regards,
Reinhard