Soft-reset on a FIS-Based-Switching AHCI interface
The AHCI spec. seems to indicate that a soft-reset can only be performed if FBS is disabled.
Looking at the LibATA and LibAHCI code at the moment, I can't see where this is done. The soft-reset happens during error recovery when the port re-enumerates devices.
Am I missing something or is this a _relatively_ less-well tested area of the LibATA/AHCI operation?
Signature · 3 lines
Richard Crewe, Software Engineer PLX Technology Ltd. Registered in England, company number 2733820 Registered Address: 25 Milton Park, Abingdon, Oxfordshire. UK. OX14 4SH
Quoted 2 lines · Richard Crewe
The AHCI spec. seems to indicate that a soft-reset can only be performed if FBS is disabled.
Can you cite section numbers / specific references for this?
Quoted 6 lines
Looking at the LibATA and LibAHCI code at the moment, I can't see where this is done. The soft-reset happens during error recovery when the port re-enumerates devices.
Am I missing something or is this a _relatively_ less-well tested area of the LibATA/AHCI operation?
I cannot see where FBS is disabled for soft-reset, either.
FBS is pretty new, hasn't changed much at all since its initial implementation on an AMD reference board, and is (obviously) only used with PMPs. FBS is a pretty small subset of the total AHCI population, so I doubt the code is exercised heavily except for a very few, large storage installations.
Jeff