Skip to contentSkip to conversation

2.6.27, kvm-kmod, and PCI device assignment

DISCUSSION Chris Friesen 2 participants 2 messages Sep 12, 2011 KVM

lore
Share & tools
lore
#0 lore raw

Hi,

I've been away a bit but I'm now coming back to this issue.

Is it expected that the kvm-kmod modules will allow PCI device assignment (aka VT-d) with older kernels? If so, then is there an expectation for how far back it will be supported? I haven't seen a clear statement of this anywhere, and I think David was interested in this as well.

Looking at the instructions at "http://www.linux-kvm.org/page/How_to_assign_devices_with_VT-d_in_KVM", step 4 is to unbind the device from the host using the "pci_stub" functionality. That code was only added to mainline for 2.6.29-rc1, so it seems like extra work will be needed for 2.6.28 and earlier.

Thanks,
Chris

Signature · 5 lines
Chris Friesen
Software Developer
GENBAND
[email protected]
www.genband.com
#1 lore raw
Quoted 10 lines · Chris Friesen

Hi,

I've been away a bit but I'm now coming back to this issue.

Is it expected that the kvm-kmod modules will allow PCI device assignment (aka VT-d) with older kernels? If so, then is there an expectation for how far back it will be supported? I haven't seen a clear statement of this anywhere, and I think David was interested in this as well.

In general, it is supposed to work, but there are likely more quirks and limitation than with a recent kernel. Example: pci_reset_function is not available for < 2.6.28, thus the assigned device may not work properly if the guest depends on a reset or after the VM ran through a reset or <who-knows>. You may also run into bugs/limitations of required kernel subsystems like the IOMMU layer that were fixed in newer kernels. kvm-kmod only addresses the kvm modules here.

Quoted 6 lines

Looking at the instructions at "http://www.linux-kvm.org/page/How_to_assign_devices_with_VT-d_in_KVM", step 4 is to unbind the device from the host using the "pci_stub" functionality. That code was only added to mainline for 2.6.29-rc1, so it seems like extra work will be needed for 2.6.28 and earlier.

pci_stub is not strictly required if you manage your system in a way that all other "interested" drivers are kept away from the assigned device.

Jan

Signature · 2 lines
Siemens AG, Corporate Technology, CT T DE IT 1
Corporate Competence Center Embedded Linux