tx25: re-add MACH_TYPE_TX25
PATCH 1/1 tx25: re-add MACH_TYPE_TX25
--- include/configs/tx25.h | 4 ++++ 1 files changed, 4 insertions(+), 0 deletions(-)
include/configs/tx25.h +4 -0
@@ -29,6 +29,10 @@#define CONFIG_MX25_CLK32 32000/* OSC32K frequency */ #define CONFIG_SYS_HZ 1000 +#ifndef MACH_TYPE_TX25 +#define MACH_TYPE_TX25 2177 +#endif +#define CONFIG_SYS_MONITOR_LEN (256 << 10)/* 256 kB for U-Boot */ /* NAND BOOT is the only boot method */
Signature · 1 line
1.7.6.4
PATCH 1/1 tx25: re-add MACH_TYPE_TX25
Quoted 11 lines · Wolfgang Denk
Signed-off-by Wolfgang Denk <[email protected]>cc Stefano Babic <[email protected]>--- include/configs/tx25.h | 4 ++++ 1 files changed, 4 insertions(+), 0 deletions(-)include/configs/tx25.h +0
-0
include/configs/tx25.h line 37
Quoted 9 lines
include/configs/tx25.h +4
-0@@ -29,6 +29,10 @@#define CONFIG_MX25_CLK32 32000/* OSC32K frequency */ #define CONFIG_SYS_HZ 1000 +#ifndef MACH_TYPE_TX25 +#define MACH_TYPE_TX25 2177 +#endif +#define CONFIG_SYS_MONITOR_LEN (256 << 10)/* 256 kB for U-Boot */
Thanks for reporting, but....
..I have already sent a fix for this last week, using also the standard mechanism in arch/arm/lib/board.c to set the mach-id:
http://patchwork.ozlabs.org/patch/122357/
As a fix, I have already applied it and I inserted it in my pull-request ro Albert. The patch is already in u-boot-arm and as far as I have tested, there should be no broken IMX boards due to missing mach type.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================
PATCH 1/1 tx25: re-add MACH_TYPE_TX25
Dear Stefano,
Quoted 5 lines · In message <[email protected]> you wrote:
Thanks for reporting, but....
..I have already sent a fix for this last week, using also the standard mechanism in
arch/arm/lib/board.cto set the mach-id:
Sorry, I missed that. Thanks.
Best regards,
Wolfgang Denk
Signature · 4 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de The Gates in my computer are AND, OR and NOT; they are not Bill.