ARM: add EDAC atomic_scrub function

From: Rob Herring <[email protected]>

Add support for architecture specific EDAC atomic_scrub to ARM. Only ARMv6+ is implemented as ldrex/strex instructions are needed. Supporting EDAC on ARMv5 or earlier is unlikely at this point anyway.

Signed-off-by Rob Herring <[email protected]>

---
 arch/arm/include/asm/edac.h |   48 +++++++++++++++++++++++++++++++++++++++++++
 1 files changed, 48 insertions(+), 0 deletions(-)
 create mode 100644 arch/arm/include/asm/edac.h

arch/arm/include/asm/edac.h new file +48 -0

new file mode 100644
index 0000000..0df7a2c
@@ -0,0 +1,48 @@
+/*
+ * Copyright 2011 Calxeda, Inc.
+ * Based on PPC version Copyright 2007 MontaVista Software, Inc.
+ *
+ * This program is free software; you can redistribute it and/or modify it
+ * under the terms and conditions of the GNU General Public License,
+ * version 2, as published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope it will be useful, but WITHOUT
+ * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
+ * FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for
+ * more details.
+ *
+ * You should have received a copy of the GNU General Public License along with
+ * this program.  If not, see <http://www.gnu.org/licenses/>.
+ */
+#ifndef ASM_EDAC_H
+#define ASM_EDAC_H
+/*
+ * ECC atomic, DMA, SMP and interrupt safe scrub function.
+ * Implements the per arch atomic_scrub() that EDAC use for software
+ * ECC scrubbing.  It reads memory and then writes back the original
+ * value, allowing the hardware to detect and correct memory errors.
+ */
+static inline void atomic_scrub(void *va, u32 size)
+{
+#if __LINUX_ARM_ARCH__ >= 6
+	unsigned int *virt_addr = va;
+	unsigned int temp, temp2;
+	unsigned int i;
+
+	for (i = 0; i < size / sizeof(*virt_addr); i++, virt_addr++) {
+		/* Very carefully read and write to memory atomically
+		 * so we are interrupt, DMA and SMP safe.
+		 */
+		__asm__ __volatile__("\n"
+			"1:	ldrex	%0, [%2]\n"
+			"	strex	%1, %0, [%2]\n"
+			"	teq	%1, #0\n"
+			"	bne	1b\n"
+			: "=&r"(temp), "=&r"(temp2)
+			: "r"(virt_addr)
+			: "cc");
+	}
+#endif
+}
+
+#endif