mx6q: mx6qsabrelite: Update the README
PATCH 1/1 mx6q: mx6qsabrelite: Update the README
The SD loader binary is now downloadable at
https://wiki.linaro.org/Boards/MX6QSabreLite
under a open-source 3-clause BSD license. Update the README for this.
The discussion shows that it's hard to change the hardware regarding the default SPI NOR boot of the SabreLite boards. I.e. this will stay the default boot. Therefore remove the 'early version of' statement.
--- doc/README.mx6qsabrelite | 12 ++++++++---- 1 files changed, 8 insertions(+), 4 deletions(-)
doc/README.mx6qsabrelite +8 -4
@@ -7,20 +7,24 @@ i.MX6q SabreLite board. --------------------------------- The recent mainline U-Boot for the Freescale i.MX6q SabreLite board supports -boot from SD card only. However, by default, the early version of SabreLite +boot from SD card only. However, by default, the SabreLite boards boot from the SPI NOR flash. These boards need to be reflashed with a small SD card loader to support boot from SD card. This small SD card loader will be flashed into the SPI NOR. The board will still boot from SPI NOR, but the loader will in turn request the BootROM to load the U-Boot from SD card. -At the moment of writing, please check with Freescale on the availablity of -this small SD loader binary. + +The SD card loader is available from + +https://wiki.linaro.org/Boards/MX6QSabreLite + +under a open-source 3-clause BSD license. To update the SPI-NOR on the SabreLite board without the Freescale manufacturing tool use the following procedure: 1. Write this SD card loader onto a large SD card using: - sudo dd if=MX6_SPI_to_SD_loader.bin of=/dev/sXx + sudo dd if=iMX6DQ_SPI_to_uSDHC3.bin of=/dev/sXx Note: Replace sXx with the device representing the SD card in your system.
Signature · 1 line
1.7.0.4
PATCH 1/1 mx6q: mx6qsabrelite: Update the README
Quoted 12 lines · Dirk Behme
The SD loader binary is now downloadable at
https://wiki.linaro.org/Boards/MX6QSabreLite
under a open-source 3-clause BSD license. Update the README for this.
The discussion shows that it's hard to change the hardware regarding the default SPI NOR boot of the SabreLite boards. I.e. this will stay the default boot. Therefore remove the 'early version of' statement.
Quoted 4 lines
Signed-off-by Dirk Behme <[email protected]>CC Stefano Babic <[email protected]>CC Jason Liu <[email protected]>---
Applied to u-boot-imx, thanks.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de =====================================================================