mx6qsabrelite: Add boot switch setting information into the README
PATCH 1/1 mx6qsabrelite: Add boot switch setting information into the README
Add boot switch setting information into the README
Signed-off-by Fabio Estevam <[email protected]>
--- doc/README.mx6qsabrelite | 3 ++- 1 files changed, 2 insertions(+), 1 deletions(-)
doc/README.mx6qsabrelite +2 -1
@@ -31,7 +31,8 @@ Note: Replace sXx with the device representing the SD card in your system. Note: This writes SD card loader at address 0 2. Put this SD card into the slot for the large SD card (SD3 on the bottom of -the board) +the board). Make sure SW1 switch is at position "00", so that it can boot +from the fuses. 3. Power-up the SabreLite, press 'space' to enter command mode in the U-Boot (the default one the board is shipped with, starting from the SPI NOR) and
Signature · 1 line
1.7.1
PATCH 1/1 mx6qsabrelite: Add boot switch setting information into the README
Quoted 4 lines · Fabio Estevam
Add boot switch setting information into the README
Signed-off-by Fabio Estevam <[email protected]>---
Applied to u-boot-imx (fix), thanks.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================