New version of Anysee E7 T2C?
Hi,
I just got a new Anysee E7 T2C DVB-USB device.
When I load the module dvb-usb-anysee.ko "Driver Anysee E30 DVB-C & DVB-T USB2.0" version 3.2.0-23-generic I get:
[ 8.353474] DVB: registering new adapter (Anysee DVB USB2.0) [ 8.356162] anysee: firmware version:1.0 hardware id:20 [ 8.356164] anysee: Unsupported Anysee version. Please report the <[email protected]>. [ 8.356167] dvb-usb: no frontend was attached by 'Anysee DVB USB2.0'
Strange thing is that hardware id:20 should be supported by the driver from what I can see in the source?
Any ideas?
/Magnus
Hi Magnus.
Dne 24. dubna 2012 21:19 Magnus Ekhall <[email protected]> napsal(a):
Quoted 13 lines
Hi,
I just got a new Anysee E7 T2C DVB-USB device.
When I load the module dvb-usb-anysee.ko "Driver Anysee E30 DVB-C & DVB-T USB2.0" version 3.2.0-23-generic I get:
[ 8.353474] DVB: registering new adapter (Anysee DVB USB2.0) [ 8.356162] anysee: firmware version:1.0 hardware id:20
[ 8.356164] anysee: Unsupported Anysee version. Please report the <[email protected]>.
[ 8.356167] dvb-usb: no frontend was attached by 'Anysee DVB USB2.0'
Quoted 4 lines
Strange thing is that hardware id:20 should be supported by the driver from what I can see in the source?
Any ideas?
I'm not sure if T2C model is supported in 3.2.0 kernel. You should better ask author of the drivers - Antti.
If you are programmer, you can check against some 3.3.x tree, as there is supported for sure.
Honza