New: 2.6.0-test10 (SMP) hangs at boot during SCSI initialization (fwd)
http://bugme.osdl.org/show_bug.cgi?id=1589
Summary: 2.6.0-test10 (SMP) hangs at boot during SCSI
initialization
Kernel Version: 2.6.10-test10
Status: NEW
Severity: normal
Owner: [email protected]
Submitter: [email protected]
Distribution: Gentoo
Hardware Environment:
please root # lspci
00:00.0 Host bridge: Advanced Micro Devices [AMD] AMD-760 MP [IGD4-2P] System Controller (rev 11)
00:01.0 PCI bridge: Advanced Micro Devices [AMD] AMD-760 MP [IGD4-2P] AGP Bridge 00:07.0 ISA bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] ISA (rev 05) 00:07.1 IDE interface: Advanced Micro Devices [AMD] AMD-768 [Opus] IDE (rev 04) 00:07.3 Bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] ACPI (rev 03) 00:09.0 SCSI storage controller: Adaptec AIC-7892A U160/m (rev 02) 00:10.0 PCI bridge: Advanced Micro Devices [AMD] AMD-768 [Opus] PCI (rev 05) 01:05.0 VGA compatible controller: nVidia Corporation NV25 [GeForce4 Ti 4400] (rev a3)
02:00.0 USB Controller: Advanced Micro Devices [AMD] AMD-768 [Opus] USB (rev 07) 02:04.0 Ethernet controller: Accton Technology Corporation EN-1216 Ethernet Adapter (rev 11)
02:06.0 FireWire (IEEE 1394): Lucent Microelectronics FW323 (rev 04) 02:07.0 Multimedia audio controller: Ensoniq 5880 AudioPCI (rev 02) 02:08.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78)
Software Environment:
unpatched 2.6.10-test10
#
# SCSI device support
#CONFIG_SCSI=yCONFIG_SCSI_PROC_FS=y
#
# SCSI support type (disk, tape, CD-ROM)
#CONFIG_BLK_DEV_SD=yCONFIG_CHR_DEV_ST=m
# CONFIG_CHR_DEV_OSST is not setCONFIG_BLK_DEV_SR=mCONFIG_BLK_DEV_SR_VENDOR=yCONFIG_CHR_DEV_SG=m
#
# Some SCSI devices (e.g. CD jukebox) support multiple LUNs #
# CONFIG_SCSI_MULTI_LUN is not set
# CONFIG_SCSI_REPORT_LUNS is not set CONFIG_SCSI_CONSTANTS=yCONFIG_SCSI_LOGGING=y
#
# SCSI low-level drivers
#
# CONFIG_BLK_DEV_3W_XXXX_RAID is not set
# CONFIG_SCSI_ACARD is not set
# CONFIG_SCSI_AACRAID is not setCONFIG_SCSI_AIC7XXX=yCONFIG_AIC7XXX_CMDS_PER_DEVICE=32CONFIG_AIC7XXX_RESET_DELAY_MS=15000
# CONFIG_AIC7XXX_PROBE_EISA_VL is not set
# CONFIG_AIC7XXX_BUILD_FIRMWARE is not set
# CONFIG_AIC7XXX_DEBUG_ENABLE is not setCONFIG_AIC7XXX_DEBUG_MASK=0CONFIG_AIC7XXX_REG_PRETTY_PRINT=y
Problem Description:
With aic7xxx=verbose, the boot gets as far as:
Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Reading SEEPROM...done. Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: BIOS eeprom is present Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Secondary High byte termination Enabled Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Secondary Low byte termination Enabled Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Primary Low Byte termination Enabled Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Primary High Byte termination Enabled Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Downloading Sequencer Program... 422 instructions downloaded Nov 24 21:51:25 s_kernel@please kernel: ahc_pci:0:9:0: Features 0x1def6, Bugs
0x40, Flags 0x20485540
and then completely hangs, nothing but a reset will break out. I have heard a report that someone else had this problem and their kernel would boot after they recompiled without SMP support. I will try that tomorrow, but it is late now.
Oh, and I should mention that 2.6.0-test9 has been working without a hitch.
Steps to reproduce:
"Martin J. Bligh" <[email protected]> wrote:
| http://bugme.osdl.org/show_bug.cgi?id=1589 | | Summary: 2.6.0-test10 (SMP) hangs at boot during SCSI | initialization | Kernel Version: 2.6.10-test10 | Status: NEW | Severity: normal | Owner: [email protected] | Submitter: [email protected] .. | and then completely hangs, nothing but a reset will break out. I have heard a | report that someone else had this problem and their kernel would boot after they | recompiled without SMP support. I will try that tomorrow, but it is late now. | | Oh, and I should mention that 2.6.0-test9 has been working without a hitch.
Does the following patch fix your problem?
http://marc.theaimsgroup.com/?l=linux-scsi&m=106965748506343&w=2
Signature · 3 lines
Dick Streefland //// Altium BV [email protected] (@ @) http://www.altium.com --------------------------------oOO--(_)--OOo---------------------------