bonding: why zero out bond_dev->dev_addr when last slave removed?
Subsystems (2)
Hi all,
I've got a couple questions about the bonding driver.
I was wondering about the rationale for zeroing out bond_dev->dev_addr when the last slave is removed from the bond.
Assuming bond0 is currently using the mac address of eth0 then doing
ifenslave -d bond0 eth0
ifenslave -d bond0 eth1
ifenslave bond0 eth1
ifenslave bond0 eth0
ends up changing the MAC address of the bond link. Given that the bond itself stays up during this time, why don't we let the bond device keep it's previous MAC address (at least if fail_over_mac is zero)?
Is this to account for the case where we move the bond to totally different devices such that the old MAC no longer belongs to one of the slaves but instead belongs to a NIC outside the bond?
Chris
Signature · 6 lines
Chris Friesen Software Designer 3500 Carling Avenue Ottawa, Ontario K2H 8E9 www.genband.com
Chris Friesen <[email protected]> wrote:
[...]
Quoted 10 lines
I was wondering about the rationale for zeroing out
bond_dev->dev_addrwhen the last slave is removed from the bond.Assuming bond0 is currently using the mac address of eth0 then doing
ifenslave -d bond0 eth0
ifenslave -d bond0 eth1
ifenslave bond0 eth1
ifenslave bond0 eth0
Quoted 7 lines
ends up changing the MAC address of the bond link. Given that the bond itself stays up during this time, why don't we let the bond device keep it's previous MAC address (at least if
fail_over_macis zero)?Is this to account for the case where we move the bond to totally different devices such that the old MAC no longer belongs to one of the slaves but instead belongs to a NIC outside the bond?
More or less. When the last slave is removed from the bond,
several properties of the bond are reset to an initial state, one of which is that the bond's MAC is reset to all zeroes.
If fail_over_mac is set to "active," then the bond must use the
MAC of one of its slaves, as the implication is that the slaves cannot or should not change their MAC addresses. In this case, I believe the bond's MAC will be set to the first active slave's MAC, so holding over the bond's MAC makes no practical difference.
For fail_over_mac=follow, if the bond kept its MAC, then it
would be possible for both slaves to end up with the same MAC (because the follow logic will set the first slave to the bond's MAC when it is made active, and the second slave will keep its MAC after enslavement, and those could be the same MAC if the second slave is the one the bond originally got its MAC from).
-J
---
-Jay Vosburgh, IBM Linux Technology Center, [email protected]