mx6qsabreauto: enable USB host interface
PATCH v2 1/1 mx6qsabreauto: enable USB host interface
From: Knut Wohlrab <[email protected]>
The USB host interface is routed to plug USB1/J30 on the mother board.
Signed-off-by Knut Wohlrab <[email protected]>
---
Changes in v2:
- Don't add an empty board_ehci_hcd_init() to mx6qsabreauto.c. It's not needed because board_ehci_hcd_init() is declared as weak.
include/configs/mx6qsabreauto.h | 11 +++++++++++ 1 files changed, 11 insertions(+), 0 deletions(-)
include/configs/mx6qsabreauto.h +11 -0
@@ -19,6 +19,17 @@#define CONFIG_MMCROOT "/dev/mmcblk0p2"#define PHYS_SDRAM_SIZE (2u * 1024 * 1024 * 1024) +/* USB Configs */ +#define CONFIG_CMD_USB +#define CONFIG_USB_EHCI +#define CONFIG_USB_EHCI_MX6 +#define CONFIG_USB_STORAGE +#define CONFIG_USB_HOST_ETHER +#define CONFIG_USB_ETHER_ASIX +#define CONFIG_MXC_USB_PORT 1 +#define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW) +#define CONFIG_MXC_USB_FLAGS 0 +#include "mx6qsabre_common.h" #define CONFIG_SYS_FSL_USDHC_NUM 2
Signature · 1 line
1.7.0.4
PATCH v2 1/1 mx6qsabreauto: enable USB host interface
Quoted 6 lines · Dirk Behme
From: Knut Wohlrab <[email protected]>
The USB host interface is routed to plug USB1/J30 on the mother board.
Signed-off-by Knut Wohlrab <[email protected]>---
Applied to u-boot-imx, thanks.
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================