r8169: smaller improvements again
Heiner Kallweit
maintainercover r8169: smaller improvements again
Series includes a number of different smaller improvements.
Heiner Kallweit (8):
r8169: add info for DASH being enabled
r8169: remove unused constant RsvdMask
r8169: improve setting WoL on runtime-resume
r8169: replace synchronize_rcu with synchronize_net
r8169: move napi_disable call and rename rtl8169_hw_reset
r8169: move updating counters to rtl8169_down
r8169: move switching optional clock on/off to pll power functions
r8169: allow setting irq coalescing if link is down
drivers/net/ethernet/realtek/r8169_main.c | 51 +++++++++++------------ 1 file changed, 25 insertions(+), 26 deletions(-)
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 1/8 r8169: add info for DASH being enabled
In case of problems it facilitates the bug analysis if we know whether DASH is active. Therefore emit a message in probe if this is the case.
--- drivers/net/ethernet/realtek/r8169_main.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-)
drivers/net/ethernet/realtek/r8169_main.c +3 -1
@@ -5432,8 +5432,10 @@ static int rtl_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) jumbo_max, tp->mac_version <=RTL_GIGA_MAC_VER_06 ? "ok" : "ko"); -if (r8168_check_dash (tp)) +if (r8168_check_dash (tp)) { +netdev_info (dev,"DASH enabled\n" );rtl8168_driver_start (tp); + }if (pci_dev_run_wake (pdev))pm_runtime_put_sync (&pdev->dev);
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 2/8 r8169: remove unused constant RsvdMask
In reply to Heiner KallweitSince 9d3679fe0f30 ("r8169: inline rtl8169_make_unusable_by_asic") this constant isn't used any longer, so remove it.
--- drivers/net/ethernet/realtek/r8169_main.c | 2 -- 1 file changed, 2 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +0 -2
@@ -529,8 +529,6 @@ enum rtl_rx_desc_bit { RxVlanTag = (1 << 16), /* VLAN tag available */ }; -#define RsvdMask 0x3fffc000 -#define RTL_GSO_MAX_SIZE_V1 32000#define RTL_GSO_MAX_SEGS_V1 24#define RTL_GSO_MAX_SIZE_V2 64000
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 3/8 r8169: improve setting WoL on runtime-resume
In reply to Heiner KallweitIn the following scenario WoL isn't configured properly:
- Driver is loaded, interface isn't brought up within 10s, so driver runtime-suspends.
- WoL is set.
- Interface is brought up, stored WoL setting isn't applied.
It has always been like that, but the scenario seems to be quite theoretical as I haven't seen any bug report yet. Therefore treat the change as an improvement.
--- drivers/net/ethernet/realtek/r8169_main.c | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +2 -4
@@ -4887,14 +4887,12 @@ static int rtl8169_runtime_resume(struct device *device)rtl_rar_set (tp, tp->dev->dev_addr); -if (!tp->TxDescArray) -return 0 ; -rtl_lock_work (tp);__rtl8169_set_wol (tp, tp->saved_wolopts);rtl_unlock_work (tp); -__rtl8169_resume (tp); +if (tp->TxDescArray) +__rtl8169_resume (tp);return 0 ; }
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 4/8 r8169: replace synchronize_rcu with synchronize_net
In reply to Heiner Kallweitrtl8169_hw_reset() may be called under RTNL lock, therefore switch to synchronize_net().
--- drivers/net/ethernet/realtek/r8169_main.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/net/ethernet/realtek/r8169_main.c +1 -1
@@ -3929,7 +3929,7 @@ static void rtl8169_tx_clear(struct rtl8169_private *tp)static void rtl8169_hw_reset (struct rtl8169_private *tp,bool going_down) {/* Give a racing hard_start_xmit a few cycles to complete. */ -synchronize_rcu (); +synchronize_net ();/* Disable interrupts */ rtl8169_irq_mask_and_ack (tp);
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 5/8 r8169: move napi_disable call and rename rtl8169_hw_reset
In reply to Heiner Kallweitrtl8169_hw_reset() meanwhile does more than a hw reset, therefore rename it to rtl8169_cleanup(). In addition move calling napi_disable() to this function.
--- drivers/net/ethernet/realtek/r8169_main.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +5 -5
@@ -3926,8 +3926,10 @@ static void rtl8169_tx_clear(struct rtl8169_private *tp)netdev_reset_queue (tp->dev); } -static void rtl8169_hw_reset (struct rtl8169_private *tp,bool going_down) +static void rtl8169_cleanup (struct rtl8169_private *tp,bool going_down) { +napi_disable (&tp->napi); +/* Give a racing hard_start_xmit a few cycles to complete. */ synchronize_net ();
@@ -3970,10 +3972,9 @@ static void rtl_reset_work(struct rtl8169_private *tp)struct net_device *dev = tp->dev;int i; -napi_disable (&tp->napi);netif_stop_queue (dev); -rtl8169_hw_reset (tp, false); +rtl8169_cleanup (tp, false);for (i =0 ; i <NUM_RX_DESC ; i++)rtl8169_mark_to_asic (tp->RxDescArray + i);
@@ -4636,9 +4637,8 @@ static void rtl8169_down(struct rtl8169_private *tp)bitmap_zero (tp->wk.flags,RTL_FLAG_MAX );phy_stop (tp->phydev); -napi_disable (&tp->napi); -rtl8169_hw_reset (tp, true); +rtl8169_cleanup (tp, true);rtl_pll_power_down (tp);
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 6/8 r8169: move updating counters to rtl8169_down
In reply to Heiner KallweitCounters are updated whenever we go down, therefore move the call to rtl8169_down().
--- drivers/net/ethernet/realtek/r8169_main.c | 8 ++------ 1 file changed, 2 insertions(+), 6 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +2 -6
@@ -4638,6 +4638,8 @@ static void rtl8169_down(struct rtl8169_private *tp)phy_stop (tp->phydev); +rtl8169_update_counters (tp); +rtl8169_cleanup (tp, true);rtl_pll_power_down (tp);
@@ -4652,9 +4654,6 @@ static int rtl8169_close(struct net_device *dev)pm_runtime_get_sync (&pdev->dev); -/* Update counters before going down */ -rtl8169_update_counters (tp); -netif_stop_queue (dev);rtl8169_down (tp);rtl8169_rx_clear (tp);
@@ -4875,9 +4874,6 @@ static int rtl8169_runtime_suspend(struct device *device)rtl8169_net_suspend (tp); -/* Update counters before going runtime suspend */ -rtl8169_update_counters (tp); -return 0 ; }
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 7/8 r8169: move switching optional clock on/off to pll power functions
In reply to Heiner KallweitRelevant chip clocks are disabled in rtl_pll_power_down(), therefore move calling clk_disable_unprepare() there. Similar for enabling the clock.
--- drivers/net/ethernet/realtek/r8169_main.c | 7 ++++--- 1 file changed, 4 insertions(+), 3 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +4 -3
@@ -2292,10 +2292,14 @@ static void rtl_pll_power_down(struct rtl8169_private *tp)default :break ; } + +clk_disable_unprepare (tp->clk); }static void rtl_pll_power_up (struct rtl8169_private *tp) { +clk_prepare_enable (tp->clk); +switch (tp->mac_version) { case RTL_GIGA_MAC_VER_25 ... RTL_GIGA_MAC_VER_33:case RTL_GIGA_MAC_VER_37 :
@@ -4826,7 +4830,6 @@ static int __maybe_unused rtl8169_suspend(struct device *device)struct rtl8169_private *tp =dev_get_drvdata (device);rtl8169_net_suspend (tp); -clk_disable_unprepare (tp->clk);return 0 ; }
@@ -4853,8 +4856,6 @@ static int __maybe_unused rtl8169_resume(struct device *device)rtl_rar_set (tp, tp->dev->dev_addr); -clk_prepare_enable (tp->clk); -if (netif_running (tp->dev))__rtl8169_resume (tp);
Signature · 1 line
2.27.0
Heiner Kallweit
maintainerPATCH 8/8 r8169: allow setting irq coalescing if link is down
In reply to Heiner KallweitSo far we can not configure irq coalescing when link is down. Allow the user to do this, and assume that he wants to configure irq coalescing for highest speed. Otherwise the irq rate is low enough anyway.
--- drivers/net/ethernet/realtek/r8169_main.c | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-)
drivers/net/ethernet/realtek/r8169_main.c +8 -4
@@ -1731,16 +1731,16 @@ struct rtl_coalesce_info {#define COALESCE_DELAY (d) { (d), 8 * (d), 16 * (d), 32 * (d) }static const struct rtl_coalesce_info rtl_coalesce_info_8169[] = { - {SPEED_10 ,COALESCE_DELAY (40960 ) }, - {SPEED_100 ,COALESCE_DELAY (2560 ) }, {SPEED_1000 ,COALESCE_DELAY (320 ) }, + {SPEED_100 ,COALESCE_DELAY (2560 ) }, + {SPEED_10 ,COALESCE_DELAY (40960 ) }, {0 }, };static const struct rtl_coalesce_info rtl_coalesce_info_8168_8136[] = { - {SPEED_10 ,COALESCE_DELAY (40960 ) }, - {SPEED_100 ,COALESCE_DELAY (2560 ) }, {SPEED_1000 ,COALESCE_DELAY (5000 ) }, + {SPEED_100 ,COALESCE_DELAY (2560 ) }, + {SPEED_10 ,COALESCE_DELAY (40960 ) }, {0 }, };#undef COALESCE_DELAY
@@ -1756,6 +1756,10 @@ rtl_coalesce_info(struct rtl8169_private *tp)else ci = rtl_coalesce_info_8168_8136; +/* if speed is unknown assume highest one */ +if (tp->phydev->speed ==SPEED_UNKNOWN ) +return ci; +for (; ci->speed; ci++) {if (tp->phydev->speed == ci->speed)return ci;
Signature · 1 line
2.27.0
David Miller
maintainerFrom: Heiner Kallweit <[email protected]>
Date: Wed, 17 Jun 2020 22:50:11 +0200
Quoted 1 line
Series includes a number of different smaller improvements.
Series applied, thanks Heiner.