ARM: sunxi: cubieboard: Add UART muxing
Subsystems (2)
PATCH 1/1 ARM: sunxi: cubieboard: Add UART muxing
We previously relied on the bootloader to do the muxing of the UART for the Cubieboard. Don't rely on it anymore and use pinctrl.
Also remove uart1, as it is not enabled by default and it's not exposed on the board headers.
Signed-off-by Emilio L?pez <[email protected]>
---
This is a followup patch to Maxime Ripard's "Extend UART support for Allwinner SoCs" series.
arch/arm/boot/dts/sun4i-a10-cubieboard.dts | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
arch/arm/boot/dts/sun4i-a10-cubieboard.dts +2 -4
@@ -37,10 +37,8 @@ }; uart0: uart at 01c28000 { - status = "okay"; - }; - - uart1: uart at 01c28400 { + pinctrl-names = "default"; + pinctrl-0 = <&uart0_pins_a>; status = "okay"; }; };
Signature · 1 line
1.8.1.5
Maxime Ripard
AppliedPATCH 1/1 ARM: sunxi: cubieboard: Add UART muxing
Le 08/03/2013 12:18, Emilio L?pez a ?crit :
Quoted 5 lines
We previously relied on the bootloader to do the muxing of the UART for the Cubieboard. Don't rely on it anymore and use pinctrl.
Also remove uart1, as it is not enabled by default and it's not exposed on the board headers.
Applied, thanks.
Maxime
Signature · 3 lines
Maxime Ripard, Free Electrons Embedded Linux, Kernel and Android engineering http://free-electrons.com