ARM: dts: AM33XX: Add support for IGEP COM AQUILA

The IGEP COM AQUILA is industrial processors SODIMM module with following highlights:

o AM3352/AM3354/AM3358/AM3359 Texas Instruments processor
o Cortex-A8 ARM CPU
o 3.3 volts Inputs / Outputs use industrial
o 256 MB DDR3 SDRAM / 128 Megabytes FLASH
o MicroSD card reader on-board
o Ethernet controller on-board
o JTAG debug connector available
o Designed for industrial range purposes

new file mode 100644
index 0000000..06eba07

arch/arm/boot/dts/am335x-igep0033.dtsi new file +42 -0

@@ -0,0 +1,265 @@
+/*
+ * am335x-igep0033.dtsi - Device Tree file for IGEP COM AQUILA AM335x
+ *
+ * Copyright (C) 2013 ISEE 2007 SL - http://www.isee.biz
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+/dts-v1/;
+
+#include "am33xx.dtsi"
+
+/ {
+       cpus {
+               cpu@0 {
+                       cpu0-supply = <&vdd1_reg>;
+               };
+       };
+
+       memory {
+               device_type = "memory";
+               reg = <0x80000000 0x10000000>; /* 256 MB */
+       };
+
+       leds {
+               pinctrl-names = "default";
+               pinctrl-0 = <&leds_pins>;
+
+               compatible = "gpio-leds";
+
+               led@0 {
+                       label = "com:green:user";
+                       gpios = <&gpio1 23 GPIO_ACTIVE_HIGH>;
+                       default-state = "on";
+               };
+       };
+
+       vbat: fixedregulator@0 {
+               compatible = "regulator-fixed";
+               regulator-name = "vbat";

arch/arm/boot/dts/am335x-igep0033.dtsi new file +115 -0

+               >;
+       };
+};
+
+&cpsw_emac0 {
+       phy_id = <&davinci_mdio>, <0>;
+};
+
+&cpsw_emac1 {
+       phy_id = <&davinci_mdio>, <1>;
+};
+
+&elm {
+       status = "okay";
+};
+
+&gpmc {
+       status = "okay";
+       pinctrl-names = "default";
+       pinctrl-0 = <&nandflash_pins>;
+
+       ranges = <0 0 0x08000000 0x10000000>;   /* CS0: NAND */
+
+       nand@0,0 {
+               reg = <0 0 0>; /* CS0, offset 0 */
+               nand-bus-width = <8>;
+               ti,nand-ecc-opt = "bch8";
+               gpmc,device-nand = "true";
+               gpmc,device-width = <1>;
+               gpmc,sync-clk-ps = <0>;
+               gpmc,cs-on-ns = <0>;
+               gpmc,cs-rd-off-ns = <44>;
+               gpmc,cs-wr-off-ns = <44>;
+               gpmc,adv-on-ns = <6>;
+               gpmc,adv-rd-off-ns = <34>;
+               gpmc,adv-wr-off-ns = <44>;
+               gpmc,we-on-ns = <0>;
+               gpmc,we-off-ns = <40>;
+               gpmc,oe-on-ns = <0>;
+               gpmc,oe-off-ns = <54>;
+               gpmc,access-ns = <64>;
+               gpmc,rd-cycle-ns = <82>;
+               gpmc,wr-cycle-ns = <82>;
+               gpmc,wait-on-read = "true";
+               gpmc,wait-on-write = "true";
+               gpmc,bus-turnaround-ns = <0>;
+               gpmc,cycle2cycle-delay-ns = <0>;
+               gpmc,clk-activation-ns = <0>;
+               gpmc,wait-monitoring-ns = <0>;
+               gpmc,wr-access-ns = <40>;
+               gpmc,wr-data-mux-bus-ns = <0>;
+
+               #address-cells = <1>;
+               #size-cells = <1>;
+               elm_id = <&elm>;
+
+               /* MTD partition table */
+               partition@0 {
+                       label = "SPL";
+                       reg = <0x00000000 0x000080000>;
+               };
+
+               partition@1 {
+                       label = "U-boot";
+                       reg = <0x00080000 0x001e0000>;
+               };
+
+               partition@2 {
+                       label = "U-Boot Env";
+                       reg = <0x00260000 0x00020000>;
+               };
+
+               partition@3 {
+                       label = "Kernel";
+                       reg = <0x00280000 0x00500000>;
+               };
+
+               partition@4 {
+                       label = "File System";
+                       reg = <0x00780000 0x007880000>;
+               };
+       };
+};
+
+&i2c0 {
+       status = "okay";
+       pinctrl-names = "default";
+       pinctrl-0 = <&i2c0_pins>;
+
+       clock-frequency = <400000>;
+
+       tps: tps@2d {
+               reg = <0x2d>;
+       };
+};
+
+&uart0 {
+       status = "okay";
+       pinctrl-names = "default";
+       pinctrl-0 = <&uart0_pins>;
+};
+
+#include "tps65910.dtsi"
+
+&tps {
+       vcc1-supply = <&vbat>;
+       vcc2-supply = <&vbat>;
+       vcc3-supply = <&vbat>;
+       vcc4-supply = <&vbat>;
+       vcc5-supply = <&vbat>;
+       vcc6-supply = <&vbat>;
+       vcc7-supply = <&vbat>;
+       vccio-supply = <&vbat>;
+
+       regulators {

arch/arm/boot/dts/am335x-igep0033.dtsi new file +45 -1

+                       regulator-name = "vdd_core";
+                       regulator-min-microvolt = <912500>;
+                       regulator-max-microvolt = <1150000>;
+                       regulator-boot-on;
+                       regulator-always-on;
+               };
+
+               vdd3_reg: regulator@4 {
+                       regulator-always-on;
+               };
+
+               vdig1_reg: regulator@5 {
+                       regulator-always-on;
+               };
+
+               vdig2_reg: regulator@6 {
+                       regulator-always-on;
+               };
+
+               vpll_reg: regulator@7 {
+                       regulator-always-on;
+               };
+
+               vdac_reg: regulator@8 {
+                       regulator-always-on;
+               };
+
+               vaux1_reg: regulator@9 {
+                       regulator-always-on;
+               };
+
+               vaux2_reg: regulator@10 {
+                       regulator-always-on;
+               };
+
+               vaux33_reg: regulator@11 {
+                       regulator-always-on;
+               };
+
+               vmmc_reg: regulator@12 {
+                       regulator-always-on;
+               };
+       };
+};
+
--

1.8.1.2