Skip to contentSkip to conversation

pmic:i2c: Replace legacy I2C_SET_BUS macro with i2c_set_bus_num()

PATCH New Lukasz Majewski 2 participants 2 messages Aug 16, 2013 – Aug 20, 2013

lore
Share & tools
lore

Lukasz Majewski

author
#0 lore raw

PATCH 1/1 pmic:i2c: Replace legacy I2C_SET_BUS macro with i2c_set_bus_num()

After introduction of unified i2c model, the I2C_SET_BUS() macro is regarded as obsolete.
Hence it is replaced with i2c_set_bus_num() function call.

Signed-off-by Lukasz Majewski <[email protected]>
Cc Heiko Schocher <[email protected]>
Cc Tom Rini <[email protected]>
---
 drivers/power/power_i2c.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/power/power_i2c.c +1 -1
index 66b3bab..ac76870 100644
@@ -98,7 +98,7 @@ int pmic_reg_read(struct pmic *p, u32 reg, u32 *val)
 
 int pmic_probe(struct pmic *p)
 {
-	I2C_SET_BUS(p->bus);
+	i2c_set_bus_num(p->bus);
 	debug("Bus: %d PMIC:%s probed!\n", p->bus, p->name);
 	if (i2c_probe(pmic_i2c_addr)) {
 		printf("Can't find PMIC:%s\n", p->name);
Signature · 1 line
1.7.10.4
#1 lore raw

PATCH 1/1 pmic:i2c: Replace legacy I2C_SET_BUS macro with i2c_set_bus_num()

Hello Lukasz,

Am 16.08.2013 15:35, schrieb Lukasz Majewski:

Quoted 10 lines

After introduction of unified i2c model, the I2C_SET_BUS() macro is regarded as obsolete.
Hence it is replaced with i2c_set_bus_num() function call.

Signed-off-by Lukasz Majewski<[email protected]>
Cc Heiko Schocher<[email protected]>
Cc Tom Rini<[email protected]>
---
  drivers/power/power_i2c.c |    2 +-
  1 file changed, 1 insertion(+), 1 deletion(-)

Applied to u-boot-i2c.git, thanks.

bye,
Heiko

Signature · 2 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany