Skip to contentSkip to conversation

I/O accounting by partition: "-cow" & "-real" map to base or snapshot or ???

linux-lvm Linda A. Walsh 1 participant 1 message Oct 3, 2013

lore
Share & tools
lore
#0 lore raw

I'm trying to display I/O data from /proc/diskstats for regular, non-thin partitions, by lv_name. "-cow" and "-real" bit confusing. When I look at the output of "dmsetup ls" different minor devs for:
name minor

Home-real               2
Home                    3
Home-snapshot           5
Home-snapshot-cow       26

(snapshot=date+time snapshot was started)

I regularly see I/O on 'Home' & 'Home-real'.

write = "dd if=/dev/zero of=1G bs=1G count=1 oflag=direct"

A 1G write to Home shows 2GB I/O on 2 partitions:
Home: 1G read
Home-real: 1G read

Is this being double reported? (i.e.
I should ignore one?) Confusing is that they don't always
show the same amount of I/O.

A write to the same filename again showed 4GB I/O on 3 partitions:
Home: 1G read + 1G write
Home-real: 1G write
Home-snap-cow: 1G write

Is there some read is copying off the
first copy to the "cow" partition? (with a 1G duplication somewhere?).

If I "overwrite"
(dd if=/dev/zero of=1G bs=1G count=1 oflag=direct conv=nocreat)
I see the same numbers as on the initial file creation (to both base and the "-real" partitions).

Could anyone clarify what's going on in the above scenarios?

(i.e. I would find each write being multiplied by 2 a bit far fetched in terms of disk-BW; Multiplied by 4... even less likely I'd think...? Thanks for any light-shed...;-)