clocksource: Provide timekeeping for efm32 SoCs
Subsystems (2)
PATCH v2 1/1 clocksource: Provide timekeeping for efm32 SoCs
An efm32 features 4 16-bit timers with a 10-bit prescaler. This driver provides clocksource and clock event device using one timer instance each.
---
Changes since (implicit) v1, sent with Message-id:1379324644-20934-1-git-send-email-u.kleine-koenig at pengutronix.de:
- drop unused #defines
- add __init to efm32_clocksource_init
- fix indention
- add a comment describing the reason for the construct in efm32_timer_init
- add device tree binding document
I created a new directory "timer" below the binding directory.
.../devicetree/bindings/timer/efm32,timer.txt | 23 ++ drivers/clocksource/Kconfig | 8 + drivers/clocksource/Makefile | 1 + drivers/clocksource/time-efm32.c | 275 +++++++++++++++++++++ 4 files changed, 307 insertions(+) create mode 100644 Documentation/devicetree/bindings/timer/efm32,timer.txt create mode 100644 drivers/clocksource/time-efm32.c
Documentation/devicetree/bindings/timer/efm32,timer.txt new file +23 -0
@@ -0,0 +1,23 @@ +* EFM32 timer hardware + +The efm32 Giant Gecko SoCs come with four 16 bit timers. Two counters can be +connected to form a 32 bit counter. Each timer has three Compare/Capture +channels and can be used as PWM or Quadrature Decoder. Available clock sources +are the cpu's HFPERCLK (with a 10-bit prescaler) or an external pin. + +Required properties: +- compatible : Should be efm32,timer +- reg : Address and length of the register set +- clocks : Should contain a reference to the HFPERCLK + +Optional properties: +- interrupts : Reference to the timer interrupt + +Example: + +timer at 40010c00 { + compatible = "efm32,timer"; + reg = <0x40010c00 0x400>; + interrupts = <14>; + clocks = <&cmu clk_HFPERCLKTIMER3>; +};
drivers/clocksource/Kconfig +8 -0
@@ -71,6 +71,14 @@ config CLKSRC_DBX500_PRCMU_SCHED_CLOCK help Use the always on PRCMU Timer as sched_clock +config CLKSRC_EFM32 + bool "Clocksource for Energy Micro's EFM32 SoCs" if !ARCH_EFM32 + depends on OF && ARM && (ARCH_EFM32 || COMPILE_TEST) + default ARCH_EFM32 + help + Support to use the timers of EFM32 SoCs as clock source and clock + event device. + config ARM_ARCH_TIMER bool select CLKSRC_OF if OF
drivers/clocksource/Makefile +1 -0
@@ -27,6 +27,7 @@ obj-$(CONFIG_VT8500_TIMER) += vt8500_timer.o obj-$(CONFIG_ARCH_NSPIRE) += zevio-timer.o obj-$(CONFIG_ARCH_BCM) += bcm_kona_timer.o obj-$(CONFIG_CADENCE_TTC_TIMER) += cadence_ttc_timer.o +obj-$(CONFIG_CLKSRC_EFM32) += time-efm32.o obj-$(CONFIG_CLKSRC_EXYNOS_MCT) += exynos_mct.o obj-$(CONFIG_CLKSRC_SAMSUNG_PWM) += samsung_pwm_timer.o obj-$(CONFIG_VF_PIT_TIMER) += vf_pit_timer.o
drivers/clocksource/time-efm32.c new file +275 -0
275 lines not on this page · raw message
Signature · 1 line
1.8.4.rc3
Daniel Lezcano
AppliedPATCH v2 1/1 clocksource: Provide timekeeping for efm32 SoCs
Quoted 6 lines · Uwe Kleine-K?nig
An efm32 features 4 16-bit timers with a 10-bit prescaler. This driver provides clocksource and clock event device using one timer instance each.
Signed-off-by Uwe Kleine-K?nig <[email protected]>---
Applied to my tree for 3.13
Thanks !
-- Daniel
Quoted 9 lines
Changes since (implicit) v1, sent with Message-id:1379324644-20934-1-git-send-email-u.kleine-koenig at pengutronix.de:
- drop unused #defines
- add__inittoefm32_clocksource_init
- fix indention
- add a comment describing the reason for the construct inefm32_timer_init
- add device tree binding document
I created a new directory "timer" below the binding directory.
Why do you say you created a new directory ?
Signature · 5 lines
<http://www.linaro.org/> Linaro.org ? Open source software for ARM SoCs Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog
PATCH v2 1/1 clocksource: Provide timekeeping for efm32 SoCs
Hello Daniel,
Quoted 9 lines · Daniel Lezcano
Quoted 6 lines · Uwe Kleine-K?nig
An efm32 features 4 16-bit timers with a 10-bit prescaler. This driver provides clocksource and clock event device using one timer instance each.
Signed-off-by Uwe Kleine-K?nig <[email protected]>---
Applied to my tree for 3.13
Thanks
Quoted 4 lines
Quoted 2 lines
- add device tree binding document
I created a new directory "timer" below the binding directory.Why do you say you created a new directory ?
That's because there was no directory for clockevent devices and clock sources before. So there is a new task to check where (if at all) the other drivers document their binding.
Best regards
Uwe
Signature · 2 lines
Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |
PATCH v2 1/1 clocksource: Provide timekeeping for efm32 SoCs
Quoted 8 lines · Uwe Kleine-K?nig
Hello Daniel,
Quoted 5 lines · Daniel Lezcano
Quoted 4 lines · Uwe Kleine-K?nig
An efm32 features 4 16-bit timers with a 10-bit prescaler. This driver provides clocksource and clock event device using one timer instance each.
Quoted 5 lines
Quoted 4 lines
Quoted 2 lines
Signed-off-by Uwe Kleine-K?nig <[email protected]>---
Applied to my tree for 3.13
Thanks
Where is your tree to be found? This commit isn't in
git://git.linaro.org/people/dlezcano/linux.git clockevents/3.13
and also it's not included in next-20131021.
Best regards and thanks
Uwe
Signature · 2 lines
Pengutronix e.K. | Uwe Kleine-K?nig | Industrial Linux Solutions | http://www.pengutronix.de/ |
PATCH v2 1/1 clocksource: Provide timekeeping for efm32 SoCs
Quoted 12 lines · Uwe Kleine-K?nig
Quoted 11 lines · Uwe Kleine-K?nig
Hello Daniel,
Quoted 8 lines · Daniel Lezcano
Quoted 6 lines · Uwe Kleine-K?nig
An efm32 features 4 16-bit timers with a 10-bit prescaler. This driver provides clocksource and clock event device using one timer instance each.
Signed-off-by Uwe Kleine-K?nig <[email protected]>---
Quoted 7 lines
Quoted 2 lines
Quoted 1 line
Applied to my tree for 3.13
Thanks
Where is your tree to be found? This commit isn't in
git://git.linaro.org/people/dlezcano/linux.gitclockevents/3.13and also it's not included in next-20131021.
Thanks for the heads up.
I synced my local tree with the tree:
git://git.linaro.org/people/dlezcano/linux.git
for the branch clockevents/3.13 and clockevents/3.12-fixes
I will send a PR as soon as I can.
Thanks
-- Daniel
Signature · 5 lines
<http://www.linaro.org/> Linaro.org ? Open source software for ARM SoCs Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog