Skip to contentSkip to conversation

SPI and I2C EEPROM

U-Boot Aaron Williams 2 participants 3 messages Nov 19, 2013

lore
Share & tools
lore
#0 lore raw

Hi all,

On one of our new boards we have both a SPI (M9256-W) and I2C (24lc256) EEPROM. I have run into a couple of issues. First of all, it looks like the eeprom command can only handle one EEPROM device. It would be useful if multiple devices could be supported.

Another issue I ran into is that the M95XXX driver is hard coded to use CS1.

Perhaps the eeprom command could be enhanced to specify whether the device should be spi or i2c rather than hard coded as well as support multiple devices?

-Aaron

Signature · 4 lines
Aaron Williams
Software Engineer
Cavium, Inc.
(408) 943-7198  (510) 789-8988 (cell)
#1 lore raw

Never mind about the multiple devices, it looks like that is supported. My problem is still that only either I2C or SPI are supported and not both.

-Aaron

Quoted 16 lines · Aaron Williams

Hi all,

On one of our new boards we have both a SPI (M9256-W) and I2C (24lc256) EEPROM. I have run into a couple of issues. First of all, it looks like the eeprom command can only handle one EEPROM device. It would be useful if multiple devices could be supported.

Another issue I ran into is that the M95XXX driver is hard coded to use CS1.

Perhaps the eeprom command could be enhanced to specify whether the device should be spi or i2c rather than hard coded as well as support multiple devices?

-Aaron

Signature · 4 lines
Aaron Williams
Software Engineer
Cavium, Inc.
(408) 943-7198  (510) 789-8988 (cell)
#2 lore raw
In reply to Aaron Williams

Hello Aaron,

Am 19.11.2013 05:18, schrieb Aaron Williams:

Quoted 3 lines

Hi all,

On one of our new boards we have both a SPI (M9256-W) and I2C (24lc256) EEPROM. I have run into a couple of issues. First of all, it looks like the eeprom command can only handle one EEPROM device. It would be useful if multiple devices could be supported.

Yes for "you run into issues"...

The current eeprom driver can handle multiple i2c eeproms on one i2c bus, see define CONFIG_SYS_I2C_MULTI_EEPROMS in common/cmd_eeprom.c

But not spi and i2c on one board ... and maybe you need also to specify the eeprom addr len?

Quoted 3 lines

Another issue I ran into is that the M95XXX driver is hard coded to use CS1.

Perhaps the eeprom command could be enhanced to specify whether the device should be spi or i2c rather than hard coded as well as support multiple devices?

Yes its software, so that could be done.

Device driver model would help here much...

bye,
Heiko

Signature · 2 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany