p1010rdb: enable mtdparts for NAND
PATCH 1/1 p1010rdb: enable mtdparts for NAND
The default partition table matches the .dts files for these boards in Linux. This allows these partitions to be used by name with U-Boot's "nand" command.
Signed-off-by Zhao Qiang <[email protected]>
--- include/configs/P1010RDB.h | 7 +++++++ 1 file changed, 7 insertions(+)
include/configs/P1010RDB.h +7 -0
@@ -329,6 +329,13 @@ extern unsigned long get_sdram_size(void);#define CONFIG_SYS_NAND_BASE_PHYS CONFIG_SYS_NAND_BASE#endif +#define CONFIG_MTD_DEVICE +#define CONFIG_MTD_PARTITION +#define CONFIG_CMD_MTDPARTS +#define MTDIDS_DEFAULT "nand0=ff800000.flash" +#define MTDPARTS_DEFAULT \ + "mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)" +#define CONFIG_SYS_NAND_CSPR (CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \ | CSPR_PORT_SIZE_8 \ | CSPR_MSEL_NAND \
Signature · 1 line
1.8.0
PATCH 1/1 p1010rdb: enable mtdparts for NAND
Quoted 6 lines · Zhao Qiang
The default partition table matches the .dts files for these boards in Linux. This allows these partitions to be used by name with U-Boot's "nand" command.
Signed-off-by Zhao Qiang <[email protected]>---
Applied to u-boot-mpc85xx/master. Thanks.
York