powerpc: spiflash:Add corenet devices support in eSPI SPL
PATCH v3 1/1 powerpc: spiflash:Add corenet devices support in eSPI SPL
Existing eSPI SPL framework assumes booting from spi-image with boot_format header which contains final u-boot Image offset and size. No such header is present in case of corenet devices like T1040 as corenet deivces use PBI-RCW based intialization.
So, for corenet deives, SPL bootloader use values provided at compilation time. These values can be defined in board specific config file.
---
Changes for v3:
Send as independent patch (not as part of patch set)
Changes for v2:
Updated description based on Sun York's inputs
drivers/mtd/spi/fsl_espi_spl.c | 5 +++++ 1 files changed, 5 insertions(+), 0 deletions(-)
drivers/mtd/spi/fsl_espi_spl.c +5 -0
@@ -31,6 +31,10 @@ void spi_boot(void)hang (); } +#ifdef CONFIG_FSL_CORENET + offset =CONFIG_SYS_SPI_FLASH_U_BOOT_OFFS ; + code_len =CONFIG_SYS_SPI_FLASH_U_BOOT_SIZE ; +#else /* * Load U-Boot image from SPI flash into RAM */
@@ -50,6 +54,7 @@ void spi_boot(void) code_len = *(u32 *)(buf +ESPI_BOOT_IMAGE_SIZE );/* Skip spl code */ code_len = code_len -CONFIG_SPL_MAX_SIZE ; +#endif /* copy code to DDR */ spi_flash_read (flash, offset, code_len, (void *)CONFIG_SYS_SPI_FLASH_U_BOOT_DST );
Signature · 1 line
1.7.4.1
PATCH v3 1/1 powerpc: spiflash:Add corenet devices support in eSPI SPL
Quoted 10 lines · Priyanka Jain
Existing eSPI SPL framework assumes booting from spi-image with
boot_formatheader which contains final u-boot Image offset and size. No such header is present in case of corenet devices like T1040 as corenet deivces use PBI-RCW based intialization.So, for corenet deives, SPL bootloader use values provided at compilation time. These values can be defined in board specific config file.
Quoted 8 lines
Signed-off-by Priyanka Jain <[email protected]>---
Changes for v3:
Send as independent patch (not as part of patch set)Changes for v2:
Updated description based on Sun York's inputs
Applied to u-boot-mpc85xx/master. Thanks.
York