ARM: omap5_uevm: Example usage of alternative HSIC USB device reset
RFC PATCH 2/2 ARM: omap5_uevm: Example usage of alternative HSIC USB device reset
This patch demonstrates the usage of the alternative method for HSIC devices reset (via the ehci-hcd and omap-ehci drivers, where this method is implemented through a separate patch; must be applied prior to this one). Board functionality is not altered; a minor improvement is the removal of the second call to omap_ehci_hcd_init() after reset which is not needed anymore.
On some other OMAP4/5 boards however this is the only method that works.
Signed-off-by Lubomir Popov <[email protected]>
--- board/ti/omap5_uevm/evm.c | 2 ++ include/configs/omap5_uevm.h | 13 ++++++++++--- 2 files changed, 12 insertions(+), 3 deletions(-)
board/ti/omap5_uevm/evm.c +2 -0
@@ -210,6 +210,7 @@ int ehci_hcd_stop(void)return ret; } +#if !defined(CONFIG_OMAP_HSIC_PORT3_RESET_GPIO )void usb_hub_reset_devices (int port) {/* The LAN9730 needs to be reset after the port power has been set. */
@@ -220,6 +221,7 @@ void usb_hub_reset_devices(int port) } }#endif +#endif #ifdef CONFIG_USB_XHCI_OMAP /**
include/configs/omap5_uevm.h +10 -3
@@ -50,10 +50,17 @@#define CONFIG_USB_EHCI_OMAP #define CONFIG_USB_STORAGE #define CONFIG_SYS_USB_EHCI_MAX_ROOT_PORTS 3 -#define CONFIG_EHCI_HCD_INIT_AFTER_RESET +/*#define CONFIG_EHCI_HCD_INIT_AFTER_RESET*/ -#define CONFIG_OMAP_EHCI_PHY2_RESET_GPIO 80 -#define CONFIG_OMAP_EHCI_PHY3_RESET_GPIO 79 +/* No ULPI PHYs on this board */ +/*#define CONFIG_OMAP_EHCI_PHY2_RESET_GPIO 80*/ +/*#define CONFIG_OMAP_EHCI_PHY3_RESET_GPIO 79*/ +/* +* Due to HSIC connect ussues with some devices, a reset is required +* upon applying port power. A GPIO is needed per HSIC device: +*/ +#define CONFIG_OMAP_HSIC_PORT2_RESET_GPIO 80/* Hub */ +#define CONFIG_OMAP_HSIC_PORT3_RESET_GPIO 79/* Ethernet Ctrlr */ /* Enabled commands */ #define CONFIG_CMD_DHCP /* DHCP Support */
Signature · 1 line
1.7.9.5