nitrogen6x: README: Only calling 'make' is enough
PATCH 1/1 nitrogen6x: README: Only calling 'make' is enough
From: Fabio Estevam <[email protected]>
No need to pass 'u-boot.imx' as parameter for 'make' because u-boot.imx is built by default.
--- board/boundary/nitrogen6x/README | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
board/boundary/nitrogen6x/README +1 -1
@@ -67,7 +67,7 @@ override auto-detection and force activation of the specified panel. To build U-Boot for one of the Nitrogen6x or SabreLite board: make nitrogen6x_config - make u-boot.imx + make Note that 'nitrogen6x' is a placeholder. The complete list of supported board configurations is shown in tha MAINTAINERS file:
Signature · 1 line
1.8.1.2
PATCH 1/1 nitrogen6x: README: Only calling 'make' is enough
Thanks Fabio,
Quoted 16 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
No need to pass 'u-boot.imx' as parameter for 'make' because u-boot.imx is built by default.
Signed-off-by Fabio Estevam <[email protected]>--- board/boundary/nitrogen6x/README | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)board/boundary/nitrogen6x/README +0
-0
board/boundary/nitrogen6x/README override auto-detection and force activation of the specified panel. · line 73
Quoted 8 lines
board/boundary/nitrogen6x/README +1
-1@@ -67,7 +67,7 @@ override auto-detection and force activation of the specified panel. To build U-Boot for one of the Nitrogen6x or SabreLite board: make nitrogen6x_config - make u-boot.imx + make Note that 'nitrogen6x' is a placeholder. The complete list of supported board configurations is shown in tha MAINTAINERS file:
PATCH 1/1 nitrogen6x: README: Only calling 'make' is enough
In reply to Fabio EstevamHi Fabio,
board/boundary/nitrogen6x/README
Quoted 13 lines · Fabio Estevam
From: Fabio Estevam <[email protected]>
No need to pass 'u-boot.imx' as parameter for 'make' because u-boot.imx is built by default.
Signed-off-by Fabio Estevam <[email protected]>--- board/boundary/nitrogen6x/README | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)board/boundary/nitrogen6x/README +0
-1--- a/board/boundary/nitrogen6x/README
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================