Skip to contentSkip to conversation

ata: CONFIG_ATA is libata

PATCH Applied Randy Dunlap 2 participants 2 messages Feb 15, 2014 – Feb 18, 2014 libata

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ata: CONFIG_ATA is libata

From: Randy Dunlap <[email protected]>

Let users know that CONFIG_ATA is the kconfig symbol for libata, since libata is mentioned in documentation and messages several times.

Also correct a grammar typo.

---
 drivers/ata/Kconfig |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/ata/Kconfig +2 -2
@@ -11,13 +11,13 @@ config HAVE_PATA_PLATFORM
 	  to update the PATA_PLATFORM entry.
 
 menuconfig ATA
-	tristate "Serial ATA and Parallel ATA drivers"
+	tristate "Serial ATA and Parallel ATA drivers (libata)"
 	depends on HAS_IOMEM
 	depends on BLOCK
 	depends on !(M32R || M68K || S390) || BROKEN
 	select SCSI
 	---help---
-	  If you want to use a ATA hard disk, ATA tape drive, ATA CD-ROM or
+	  If you want to use an ATA hard disk, ATA tape drive, ATA CD-ROM or
 	  any other ATA device under Linux, say Y and make sure that you know
 	  the name of your ATA host adapter (the card inside your computer
 	  that "speaks" the ATA protocol, also called ATA controller),
Applied
#1 lore raw
Quoted 9 lines · Randy Dunlap

From: Randy Dunlap <[email protected]>

Let users know that CONFIG_ATA is the kconfig symbol for libata, since libata is mentioned in documentation and messages several times.

Also correct a grammar typo.

Applied to libata/for-3.15.

Thanks.

Signature · 1 line
tejun