Skip to contentSkip to conversation

advice on JTAG

DISCUSSION Rodolfo Giometti 3 participants 3 messages Dec 12, 2005 MIPS

lore
Share & tools
lore
#0 lore raw

Hello,

I'm looking for a good JTAG system to debug a MIPS AU1100 based board.

I'd like to have the possibility to put hardware and software break points in u-boot and linux source code. Also I prefere a system who completely supports the GNU/Linux system as host.

Can you please suggest me some links? :)

Thanks in advance,

Rodolfo

Signature · 4 lines
GNU/Linux Solutions                  e-mail:    [email protected]
Linux Device Driver                             [email protected]
Embedded Systems                     		[email protected]
UNIX programming                     phone:     +39 349 2432127
#1 lore raw
Quoted 3 lines · In message <[email protected]> you wrote:

I'm looking for a good JTAG system to debug a MIPS AU1100 based board.

Abatron BDI2000...

Quoted 3 lines

I'd like to have the possibility to put hardware and software break points in u-boot and linux source code. Also I prefere a system who completely supports the GNU/Linux system as host.

...with firmware "bdiGDB".

Quoted 1 line

Can you please suggest me some links? :)

http://www.abatron.ch/products/xr/aspx/r.1/Sv.63713d7b43526570313d7b693d394f54565743484b33513244474b394a594556537d7d/rx/products_detail.htm

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected]
Faith may be defined briefly as an illogical belief in the  occurence
of the improbable.                                    - H. L. Mencken
#2 lore raw

I'll second that. I own at least 6 different JTAG adapters for different processors, and the BDI2000 is the best hands down.

Ed Okerson

Quoted 27 lines
Quoted 3 lines · In message <[email protected]> you wrote:

I'm looking for a good JTAG system to debug a MIPS AU1100 based board.

Abatron BDI2000...

Quoted 3 lines

I'd like to have the possibility to put hardware and software break points in u-boot and linux source code. Also I prefere a system who completely supports the GNU/Linux system as host.

...with firmware "bdiGDB".

Quoted 1 line

Can you please suggest me some links? :)

http://www.abatron.ch/products/xr/aspx/r.1/Sv.63713d7b43526570313d7b693d394f54565743484b33513244474b394a594556537d7d/rx/products_detail.htm

Best regards,

Wolfgang Denk

--
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] Faith may be defined briefly as an illogical belief in the occurence
of the improbable. - H. L. Mencken