query regarding not returning error if request_irq fails after rtc registration
in ds1343 driver after the rtc is registered using devm_rtc_device_register i am requesting irq using devm_request_threaded_irq, in case this request fails instead of the driver bailing out it just uses dev_err to show the error and the driver probe returns zero
my question is that the set_alarm and alarm_irq_enable is still active, so should i use some flag in the global private variable of the driver so that if the request irq fails, then using this flag the set_alarm and alarm_irq_enable can return error since there is no irq handler for the rtc interrupt
or is there any other solution
or let the set_alarm and alarm_irq_enable routine be as it is and will not harm
Thanks and Regards
Raghavendra Chandra Ganiga
Contact: +919594554858
Quoted 7 lines · On Thu, 15 May 2014 22:15:14 +0530 RAGHAVENDRA GANIGA <[email protected]>…
my question is that the
set_alarmandalarm_irq_enableis still active, so should i use some flag in the global private variable of the driver so that if the request irq fails, then using this flag theset_alarmandalarm_irq_enablecan return error since there is no irq handler for the rtc interrupt
or is there any other solution
or let theset_alarmandalarm_irq_enableroutine be as it is and will
you can use a flag (or set the irq to -1)
Signature · 6 lines
Best regards, Alessandro Zummo, Tower Technologies - Torino, Italy http://www.towertech.it