ARM: shmobile: lager: Add VDD MPU regulator for DVFS
Subsystems (2)
PATCH v2 1/8 ARM: shmobile: lager: Add VDD MPU regulator for DVFS
From: Benoit Cousson <[email protected]>
The CA15 cluster is capable of voltage scaling. Add the regulator in the i2c3 node, to allow the generic CPUFreq driver to use it.
Enable the i2c3 pin mux and the device node as well since the da9210 is connected to that bus.
Note: In R-CAR Gen2, each frequency is using the same voltage, and DVS control is not used. Therefore, this patch set the voltage(Vmin/Vmax) to 1000mv.
---
Changes since version 1:
- added this patch for enabling da9210 regulator.
- fixed subject.
arch/arm/boot/dts/r8a7790-lager.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+)
arch/arm/boot/dts/r8a7790-lager.dts +21 -0
@@ -204,6 +204,11 @@ "msiof1_tx"; renesas,function = "msiof1"; }; + + i2c3_pins: i2c3 { + renesas,groups = "i2c3"; + renesas,function = "i2c3"; + }; }; ðer {
@@ -317,3 +322,19 @@ cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>; status = "okay"; }; + +&i2c3 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c3_pins>; + status = "okay"; + + vdd_dvfs: regulator@68 { + compatible = "diasemi,da9210"; + reg = <0x68>; + + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1000000>; + regulator-boot-on; + regulator-always-on; + }; +};
Signature · 1 line
1.7.9.5
Quoted 8 lines · Gaku Inami
From: Benoit Cousson <[email protected]>
The CA15 cluster is capable of voltage scaling. Add the regulator in the i2c3 node, to allow the generic CPUFreq driver to use it.
Enable the i2c3 pin mux and the device node as well since the da9210 is connected to that bus.
Quoted 7 lines
Note: In R-CAR Gen2, each frequency is using the same voltage, and DVS control is not used. Therefore, this patch set the voltage(Vmin/Vmax) to 1000mv.
Signed-off-by Benoit Cousson <[email protected]>[[email protected]: Changes Vmin for disabling DVS]Signed-off-by Gaku Inami <[email protected]>
Thanks, I have queued this up with Magnus's Ack.
Quoted 48 lines
---
Changes since version 1:
- added this patch for enabling da9210 regulator.
- fixed subject.arch/arm/boot/dts/r8a7790-lager.dts | 21 +++++++++++++++++++++ 1 file changed, 21 insertions(+)arch/arm/boot/dts/r8a7790-lager.dts +21
-0@@ -204,6 +204,11 @@ "msiof1_tx"; renesas,function = "msiof1"; }; + + i2c3_pins: i2c3 { + renesas,groups = "i2c3"; + renesas,function = "i2c3"; + }; }; ðer {@@ -317,3 +322,19 @@ cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>; status = "okay"; }; + +&i2c3 { + pinctrl-names = "default"; + pinctrl-0 = <&i2c3_pins>; + status = "okay"; + + vdd_dvfs: regulator@68 { + compatible = "diasemi,da9210"; + reg = <0x68>; + + regulator-min-microvolt = <1000000>; + regulator-max-microvolt = <1000000>; + regulator-boot-on; + regulator-always-on; + }; +};Signature · 1 line
1.7.9.5