xfs/291: use xfs_repair -f when repairing a fs image
PATCH 1/1 xfs/291: use xfs_repair -f when repairing a fs image
test xfs/291 creates an xfs_metadump image and runs repair on it. Technically, this is supposed to require "-f" to specify that the target of the repair is a file; this allows buffered IO fallback in the case where the image sector size is smaller than the device sector size. And in fact if we create the image on a hard 4k device, the test will fail when repair is unable to operate on the image.
So add that -f!
Signed-off-by Eric Sandeen <[email protected]>
---
tests/xfs/291 +1 -1
@@ -122,7 +122,7 @@ _xfs_check $SCRATCH_DEV >> $seqres.full 2>&1 || _fail "xfs_check failed" # Can xfs_metadump cope with this monster? _scratch_metadump $tmp.metadump || _fail "xfs_metadump failed" xfs_mdrestore $tmp.metadump $tmp.img || _fail "xfs_mdrestore failed" -xfs_repair $tmp.img >> $seqres.full 2>&1 || _fail "xfs_repair of metadump failed" +xfs_repair -f $tmp.img >> $seqres.full 2>&1 || _fail "xfs_repair of metadump failed" # Yes it can; success, all done status=0