powerpc/b4860: Updated default hwconfig so as to enable only
PATCH v2 1/1 powerpc/b4860: Updated default hwconfig so as to enable only
CPC1 is not being enabled by default as powerpc is supposed to use only CPC2.
Though by editing hwconfig en_cpc option,
CPC1 can also be enabled
Signed-off-by Shaveta Leekha <[email protected]>
Signed-off-by Sandeep Singh <[email protected]>
---
Tested on B4860QDS
Changes in V2:
Inserted "en_cpc:cpc2" at right place,
not to broke into the settings for DDR
include/configs/B4860QDS.h | 11 +++++++++-- 1 files changed, 9 insertions(+), 2 deletions(-)
include/configs/B4860QDS.h +9 -2
@@ -819,9 +819,16 @@ unsigned long get_board_ddr_clk(void);#define __USB_PHY_TYPE ulpi +#ifdef CONFIG_PPC_B4860 +#define HWCONFIG "hwconfig=fsl_ddr:ctlr_intlv=null," \ + "bank_intlv=cs0_cs1;" \ + "en_cpc:cpc2;" +#else +#define HWCONFIG "hwconfig=fsl_ddr:ctlr_intlv=null,bank_intlv=cs0_cs1;" +#endif +#define CONFIG_EXTRA_ENV_SETTINGS \ - "hwconfig=fsl_ddr:ctlr_intlv=null," \ - "bank_intlv=cs0_cs1;" \ + HWCONFIG \ "usb1:dr_mode=host,phy_type=" __stringify(__USB_PHY_TYPE) "\0"\ "netdev=eth0\0" \ "uboot=" __stringify(CONFIG_UBOOTPATH) "\0" \
Signature · 1 line
1.7.6.GIT
PATCH v2 1/1 powerpc/b4860: Updated default hwconfig so as to enable only
Quoted 5 lines · Shaveta Leekha
CPC1 is not being enabled by default as powerpc is supposed to use only CPC2.
Though by editing hwconfigen_cpcoption,
CPC1 can also be enabled
Quoted 8 lines
Signed-off-by Shaveta Leekha <[email protected]>Signed-off-by Sandeep Singh <[email protected]>---
Tested on B4860QDSChanges in V2:
Inserted "en_cpc:cpc2" at right place,
not to broke into the settings for DDR
Appended cpc2 to the subject.
Applied to u-boot-mpc85xx, awaiting upstream.
York