powerpc/t104xrdb: Set DDR ODT to 75ohm
PATCH 1/1 powerpc/t104xrdb: Set DDR ODT to 75ohm
DDR-ODT require cfg_dram_type switch set properly as per DDR type. T1040RDB, T1042RDB boards have DDR3L type DDR, so cfg_dram_type should be set to OFF for DDR3L
Update t104xrdb/README for switch setting
Signed-off-by Priyanka Jain <[email protected]>
--- board/freescale/t104xrdb/README | 6 +++--- board/freescale/t104xrdb/ddr.c | 4 ++-- 2 files changed, 5 insertions(+), 5 deletions(-)
board/freescale/t104xrdb/README +3 -3
@@ -259,15 +259,15 @@ Switch Settings: (ON is 0, OFF is 1) =============== NAND boot SW setting: SW1: 10001000 -SW2: 00111001 +SW2: 00111011 SW3: 11110001 SPI boot SW setting: SW1: 00100010 -SW2: 10111001 +SW2: 10111011 SW3: 11100001 SD boot SW setting: SW1: 00100000 -SW2: 00111001 +SW2: 00111011 SW3: 11100001
board/freescale/t104xrdb/ddr.c +2 -2
@@ -105,8 +105,8 @@ found: popts->zq_en =1 ;/* DHC_EN =1, ODT = 75 Ohm */ - popts->ddr_cdr1 =DDR_CDR1_DHC_EN |DDR_CDR1_ODT (DDR_CDR_ODT_OFF ); - popts->ddr_cdr2 =DDR_CDR2_ODT (DDR_CDR_ODT_OFF ); + popts->ddr_cdr1 =DDR_CDR1_DHC_EN |DDR_CDR1_ODT (DDR_CDR_ODT_75ohm); + popts->ddr_cdr2 =DDR_CDR2_ODT (DDR_CDR_ODT_75ohm); }phys_size_t initdram (int board_type)
Signature · 1 line
1.7.4.1
PATCH 1/1 powerpc/t104xrdb: Set DDR ODT to 75ohm
Quoted 7 lines · Priyanka Jain
DDR-ODT require
cfg_dram_typeswitch set properly as per DDR type. T1040RDB, T1042RDB boards have DDR3L type DDR, socfg_dram_typeshould be set to OFF for DDR3L
Update t104xrdb/README for switch settingSigned-off-by Priyanka Jain <[email protected]>---
Applied to u-boot-mpc85xx, awaiting upstream.
York