arm: m28evk: Test if bootscript exists before loading it
PATCH 1/4 arm: m28evk: Test if bootscript exists before loading it
Make sure the boot.scr exists on the card before loading it from the card to avoid annoying message on the console.
--- include/configs/m28evk.h | 2 ++ 1 file changed, 2 insertions(+)
include/configs/m28evk.h +2 -0
@@ -279,10 +279,12 @@"bootm ${kernel_addr_r}\0" \"try_bootscript=" \"mmc rescan;" \ +"if test -e mmc 0:2 ${bootscript} ; then " \"if ext4load mmc 0:2 ${kernel_addr_r} ${bootscript};" \"then;" \"\techo Running bootscript...;" \"\tsource ${kernel_addr_r};" \ +"fi ; " \"fi\0" /* The rest of the configuration is shared */
Signature · 1 line
2.1.0
PATCH 2/4 arm: m53evk: Test if bootscript exists before loading it
Make sure the boot.scr exists on the card before loading it from the card to avoid annoying message on the console.
--- include/configs/m53evk.h | 2 ++ 1 file changed, 2 insertions(+)
include/configs/m53evk.h +2 -0
@@ -348,10 +348,12 @@"bootm ${kernel_addr_r}\0" \"try_bootscript=" \"mmc rescan;" \ +"if test -e mmc 0:1 ${bootscript} ; then " \"if ext4load mmc 0:1 ${kernel_addr_r} ${bootscript};" \"then;" \"\techo Running bootscript...;" \"\tsource ${kernel_addr_r};" \ +"fi ; " \ "fi\0"#endif /* __M53EVK_CONFIG_H__ */
Signature · 1 line
2.1.0
PATCH 2/4 arm: m53evk: Test if bootscript exists before loading it
Quoted 6 lines · Marek Vasut
Make sure the boot.scr exists on the card before loading it from the card to avoid annoying message on the console.
Signed-off-by Marek Vasut <[email protected]>Cc Stefano Babic <[email protected]>---
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================
PATCH 3/4 arm: m28evk: Enable FS_GENERIC
In reply to Marek VasutEnable the CONFIG_CMD_FS_GENERIC on m28evk to avoid per-fs specific commands and tweak the environment to cater for this new option.
--- include/configs/m28evk.h | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
include/configs/m28evk.h +3 -2
@@ -32,6 +32,7 @@#define CONFIG_CMD_EXT4 #define CONFIG_CMD_EXT4_WRITE #define CONFIG_CMD_FAT +#define CONFIG_CMD_FS_GENERIC #define CONFIG_CMD_GPIO #define CONFIG_CMD_GREPENV #define CONFIG_CMD_I2C
@@ -236,7 +237,7 @@"addargs=run addcons addmtd addmisc\0" \"mmcload=" \"mmc rescan ; " \ -"ext4load mmc 0:2 ${kernel_addr_r} ${bootfile}\0" \ +"load mmc 0:2 ${kernel_addr_r} ${bootfile}\0" \"ubiload=" \"ubi part UBI ; ubifsmount ubi0:rootfs ; " \"ubifsload ${kernel_addr_r} /boot/${bootfile}\0" \
@@ -280,7 +281,7 @@"try_bootscript=" \"mmc rescan;" \"if test -e mmc 0:2 ${bootscript} ; then " \ -"if ext4load mmc 0:2 ${kernel_addr_r} ${bootscript};" \ +"if load mmc 0:2 ${kernel_addr_r} ${bootscript};" \"then;" \"\techo Running bootscript...;" \"\tsource ${kernel_addr_r};" \
Signature · 1 line
2.1.0
PATCH 3/4 arm: m28evk: Enable FS_GENERIC
Quoted 6 lines · Marek Vasut
Enable the
CONFIG_CMD_FS_GENERICon m28evk to avoid per-fs specific commands and tweak the environment to cater for this new option.Signed-off-by Marek Vasut <[email protected]>Cc Stefano Babic <[email protected]>---
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================
PATCH 4/4 arm: m53evk: Enable FS_GENERIC
In reply to Marek VasutEnable the CONFIG_CMD_FS_GENERIC on m53evk to avoid per-fs specific commands and tweak the environment to cater for this new option.
--- include/configs/m53evk.h | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-)
include/configs/m53evk.h +3 -2
@@ -38,6 +38,7 @@#define CONFIG_CMD_EXT4 #define CONFIG_CMD_EXT4_WRITE #define CONFIG_CMD_FAT +#define CONFIG_CMD_FS_GENERIC #define CONFIG_CMD_GREPENV #define CONFIG_CMD_I2C #define CONFIG_CMD_MII
@@ -305,7 +306,7 @@"addargs=run addcons addmtd addmisc\0" \"mmcload=" \"mmc rescan ; " \ -"ext4load mmc 0:1 ${kernel_addr_r} ${bootfile}\0" \ +"load mmc 0:1 ${kernel_addr_r} ${bootfile}\0" \"ubiload=" \"ubi part UBI ; ubifsmount ubi0:rootfs ; " \"ubifsload ${kernel_addr_r} /boot/${bootfile}\0" \
@@ -349,7 +350,7 @@"try_bootscript=" \"mmc rescan;" \"if test -e mmc 0:1 ${bootscript} ; then " \ -"if ext4load mmc 0:1 ${kernel_addr_r} ${bootscript};" \ +"if load mmc 0:1 ${kernel_addr_r} ${bootscript};" \"then;" \"\techo Running bootscript...;" \"\tsource ${kernel_addr_r};" \
Signature · 1 line
2.1.0
PATCH 4/4 arm: m53evk: Enable FS_GENERIC
Quoted 6 lines · Marek Vasut
Enable the
CONFIG_CMD_FS_GENERICon m53evk to avoid per-fs specific commands and tweak the environment to cater for this new option.Signed-off-by Marek Vasut <[email protected]>Cc Stefano Babic <[email protected]>---
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================
PATCH 1/4 arm: m28evk: Test if bootscript exists before loading it
In reply to Marek VasutQuoted 6 lines · Marek Vasut
Make sure the boot.scr exists on the card before loading it from the card to avoid annoying message on the console.
Signed-off-by Marek Vasut <[email protected]>Cc Stefano Babic <[email protected]>---
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================